1
Omega General Help / Re: 2.6 V6 Intermittent Starting and Rough Running
« on: 22 March 2023, 11:57:15 »
Well that was fun!!
Cleaned out plug wells on 246 bank (135 clean as a whistle), replaced gaskets, plugs and coil packs, cleaned out breathers as advised and behold it runs a treat!
Sorted out the windscreen plastic strip so it now attaches to the screen but the foam had rotted away. Rather than put silicon down I followed a previous post and made a deflector plate over the back right. I have read the threads about scuttle leaks and can see the issue but when it's getting late and you are working on the drive an effective engineering solution always wins!!
Only query now is EML is on with P1110-4 Intake manifold 1 open. I'm sure I plugged everything back in but are there any pictures of where this item is?
Look forward to any advice!!
Fuse.
Cleaned out plug wells on 246 bank (135 clean as a whistle), replaced gaskets, plugs and coil packs, cleaned out breathers as advised and behold it runs a treat!
Sorted out the windscreen plastic strip so it now attaches to the screen but the foam had rotted away. Rather than put silicon down I followed a previous post and made a deflector plate over the back right. I have read the threads about scuttle leaks and can see the issue but when it's getting late and you are working on the drive an effective engineering solution always wins!!
Only query now is EML is on with P1110-4 Intake manifold 1 open. I'm sure I plugged everything back in but are there any pictures of where this item is?
Look forward to any advice!!
Fuse.