Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Cruise Control Stopped Working!!!

« on: 30 September 2015, 17:04:45 »

Hi,

The Cruise Control is suddenly stopped working in my Omega B 2.0 L model 1996 (manual transmission)...
The last maintenance i did to my car was replacing the clutch disk, is there any deal with this?
If anybody can tell me how to inspect this system manually and what should I have to start to check?

Thanx for help...

2

Omega General Help / Re: Clutch engage point

« on: 24 June 2015, 23:46:47 »

Your Help Pls.

3

Omega General Help / Re: Clutch engage point

« on: 24 June 2015, 00:28:30 »

Yes I did, even it was good

4

Omega General Help / Clutch engage point

« on: 23 June 2015, 23:14:36 »

Hi,
I have Omega B 1996 with a hydraulic clutch system...
I changed the friction plate and the pressure plate but my car still start move just when the pedal near the top.
So, is the clutch pedal engage point adjustable or not? If yes, how to do that...
Thanks for help

5

Omega General Help / Re: Clutch pedal adjustment

« on: 21 June 2015, 20:03:07 »

It's a hydroloc system and there is no cable between the pedal and the gearbox...

6

Omega General Help / Clutch pedal adjustment

« on: 21 June 2015, 19:27:45 »

Hi,
I have Omega B 2.0l model 1996...
The cluctch pedal is very high and The car start to move just when the pedal is very near to top...
Is there any way to adjust the pedal level?
If anybody have pics please.
Thanks

7

Omega General Help / Re: Paper Clip Test Result, need more help

« on: 29 October 2014, 14:23:02 »

Dears,
I replaced the ICV with new original one but there is nothing changed, unstable engine for few seconds each time I stop my car...
I checked for air leackes but everything is normal...
I have two qiestions please;
- when I disconnect the ICV the engine keep running with lower RPM, is that norma or it must stop?
- when I disconnect the air flow sensor a disturbance in the engine is noticed but not stoped running, is that normal?

8

Omega General Help / Re: Paper Clip Test Result, need more help

« on: 23 October 2014, 13:26:03 »

So, there is no way to reset the ECU manually ( such as removing the battery cables and touch one by the other)?

9

Omega General Help / Re: Paper Clip Test Result, need more help

« on: 23 October 2014, 11:07:12 »

So there is no way to reset the EMC manually?

10

Omega General Help / Re: Paper Clip Test Result, need more help

« on: 23 October 2014, 04:43:54 »

How to clear the codes please?

11

Omega General Help / Re: Paper Clip Test Result, need more help

« on: 22 October 2014, 17:25:05 »

Thank you very much...
Regarding the unstability, I noticed that the maximum irregular RPM happend when the airconditioning system is on, and when it's Off the engin seems to be more stable...
Is that inssure that the ICV is not working normaly?!!!

12

Omega General Help / Oxygen Sensor (LAMBDA)

« on: 22 October 2014, 09:18:06 »

Hi,

How many Oxygen Sensor in Omega B 2.0L Model 1996 and where located?
If pictures available please.

Thanks in advance

13

Omega General Help / Re: Paper Clip Test Result, need more help

« on: 22 October 2014, 08:27:02 »

Thank you all for your replays and advises...
I tried to check the faults with a code readers that available in the workshops here but nothing I get, that's why I did the paper clip test...
I think I'll replace the Oxygen Sensor first, if nothing changed I'll go to replace the ICV.
and I'll give you the result...

14

Omega General Help / Re: Paper Clip Test Result, need more help

« on: 21 October 2014, 17:42:12 »

Thak you very much,
But there is no code of the three above refeer to icv fault!!!
The thee code are;  38, 53 and 91

15

Omega General Help / Re: Paper Clip Test Result, need more help

« on: 21 October 2014, 11:36:34 »

I did clean the icv but nothing change...
What do you mean by (trims)?
And what about the code 53?

Thaks for your interest...