Omega Owners Forum
Omega Help Area => Omega Electrical and Audio Help => Topic started by: familyman on 21 December 2006, 22:40:44
-
Using my computer today and went to range setting and remembered that since i've had the car this has never worked, just diplays 3 dashes, rest of functions fine inc inst mpg, and no fault with dislay again all working fine. Tried pressing the reset and even started the stop watch but made no difference.
Any one got any ideas out there
And cheers by the way for your help c/d fault turned out to be the cable, broken wire behind c/d player under thick plastic sheath, quick solder job and all was fine
-
It may have a problem reading tank contents, or it may have incorrect programming.
Press both stalk buttons together for 3 secs, and post back the numbers....
-
Hi TheBoy no's as displayed are
007 04
24328
any good to you?
cheers :P
-
Hi TheBoy no's as displayed are
007 04
24328
any good to you?
cheers :P
Just checking now...
-
Doesn't seem valid for pre mini facelift Omega. Couple of Q's...
Is the computer function lines below the Radio display line on MID?
Could the MID have been replaced with one from a Vectra?
-
I'm gonna stick my neck out and suggest the MID has come from a 1.8 manual Veccy with 15" wheels....
-
Hey again. display has date at top changes to radio/cd functions
below that is computer functions
below that is time next to that is check lamp
computer functions scrolling through are outside temp 0
inst fuel consumption
average consumption
average speed
range---
stopwatch then back to the top
If it is a Vectra one can it be reflashed to correct car or will i have to replace unit? :(
-
Hey again. display has date at top changes to radio/cd functions
below that is computer functions
below that is time next to that is check lamp
computer functions scrolling through are outside temp 0
inst fuel consumption
average consumption
average speed
range---
stopwatch then back to the top
If it is a Vectra one can it be reflashed to correct car or will i have to replace unit? :(
Yes, pre mini facelift type. Presumably, it can be reprogrammed. Never tried it myself, but no reason why it can't... ...not sure if this would fix range problem - that may be unrelated?
-
Thanks TheBoy see what i can do, Know a guy who knows a guy etc.... may be able to have someone play with tech 1 or 2?
Cheers and have a good Christmas, hope Santa brings you lots of toys :y
-
Thanks TheBoy see what i can do, Know a guy who knows a guy etc.... may be able to have someone play with tech 1 or 2?
Cheers and have a good Christmas, hope Santa brings you lots of toys :y
Either a Tech1 or Tech2 should be able to reprogram that MID. Mini Facelift MIDs (computer lines on top) will most likely need a Tech2.
-
Also check the wiring to pin 26 of the MID......it should read the same voltage as that on pin 20 of the instrument panel....this is the fuel level sender feed