121
Omega General Help / Quick cam cover replacement question
« on: 27 July 2016, 08:02:40 »
Replaced cam cover gaskets yesterday. But ran out of time so plenum still on bench and car in garage.
That awkward passenger side was a sod. And had to redo it 2 or 3 times so it got messy with the silicon sealer
Any ways in the link below....
http://www.omegaowners.com/forum/index.php?topic=90542.0
See jaimes picture 8 where the sealer goes. Just behind it is a little square cut out on the cam cap. Is this an oil passage? Cos if so I reckon I may Have got some on it and I'll have to go in and do it again after cleaning it.
Cheers guys
That awkward passenger side was a sod. And had to redo it 2 or 3 times so it got messy with the silicon sealer
Any ways in the link below....
http://www.omegaowners.com/forum/index.php?topic=90542.0
See jaimes picture 8 where the sealer goes. Just behind it is a little square cut out on the cam cap. Is this an oil passage? Cos if so I reckon I may Have got some on it and I'll have to go in and do it again after cleaning it.
Cheers guys