1
Omega Electrical and Audio Help / Re: Megamos interior light wiring
« on: 12 June 2017, 18:30:24 »
Thank you Vega! That was helpful!
I did a truth table for these four pins: pin 1, 2, 8 and 9 and for my Vectra A I'm going to need:
pin 1 - to be connected to the current GND cable (this is switched from open doors / light switch)
pin 2 - to be connected to the current 12V cable (this turned out to be constant 12V)
pin 8 - to be connected to constant GND, like from chassis
pin 9 - to be connected to the current 12V cable (this turned out to be constant 12V)
Will wire it tomorrow and see how this theory works.
I did a truth table for these four pins: pin 1, 2, 8 and 9 and for my Vectra A I'm going to need:
pin 1 - to be connected to the current GND cable (this is switched from open doors / light switch)
pin 2 - to be connected to the current 12V cable (this turned out to be constant 12V)
pin 8 - to be connected to constant GND, like from chassis
pin 9 - to be connected to the current 12V cable (this turned out to be constant 12V)
Will wire it tomorrow and see how this theory works.