Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: nixoro on 13 July 2006, 09:34:15
-
I have had one sat in my boot for a while now just never got round to fitting it.
Can anyone help with which wire goes where. So far I have put on the mount to make sure thats ok it just needs to be wired in.
I plan to use connectors on cut wires so if I want to keep it I can just remove and use on my next car.
Any advice would be most appreciated.
-
Will put something in the technical guides section in the next couple of days as I am currently doing the same job on my Estate.
It requries at least 3 wires connecting (all available from the courtesy light) plus the fourth is optional (to the reverse lights, drivers foot well)
-
Cheers mark DTM
I will keep a watch out for that.
Will you be connecting yours up to the reverse lights.
Is this the recommended or is it not essential.
-
If connected properly it will turn off the self dimming function when reverse is selected! ;D
-
I will wire that in to as its useful.
for info, the wires to connect are:
brown to earth
black to ignition feed (available on interior light)
white/black to reversing light wire (found in the drivers footwelll - same colour)
grey/black to the interior light grey wire.
I will post the pin numbers as well along with a picture of the connector as at least one of the above mentioned colours is duplicated.
-
Cheers Marks DTM & Rossphim
Might aswell do the job properly shall see about wiring in the reverse lights aswell.
-
I added one, but just wired up Ign. and 0v. A really nice retro-fit. And it works well too.
-
This is an interesting thread....
I was going to add this gadget to my meega, but thought as there wasnt a wiring loom about when i took the orig mirror off, i wouldnt be able to...
Didnt realise the feeds just came off the interior light and reverse light feed
I will keep my eye on this thread :)
-
I will wire that in to as its useful.
for info, the wires to connect are:
brown to earth
black to ignition feed (available on interior light)
white/black to reversing light wire (found in the drivers footwelll - same colour)
grey/black to the interior light grey wire.
I will post the pin numbers as well along with a picture of the connector as at least one of the above mentioned colours is duplicated.
Look forward to reading your guide, looking at the piece of loom I have it has two grey/black cables.
-
Didnt get chance to do it last night.....had to change a dis pack on somebodies car..... ;)