Omega Owners Forum
Chat Area => General Car Chat => Topic started by: commodore on 08 December 2009, 11:02:39
-
changed the front pads on my mates 03 vectra 2.2 elite the other day and re-connected the sensor but the brake warning light is still illuminated....the rear pads are very low also but i was told the rears dont have wear sensors??? does the light need re-setting in some way or is it the rears showing now? many thanks guys.
-
you may of broke the sensor when putting back in pad, dose happen.
-
changed the front pads on my mates 03 vectra 2.2 elite the other day and re-connected the sensor but the brake warning light is still illuminated....the rear pads are very low also but i was told the rears dont have wear sensors??? does the light need re-setting in some way or is it the rears showing now? many thanks guys.
Probably the sensor is not seated right mate,and i have never known them to have rear sensors. :y
-
Rear brakes on Veccy "C" does not have sensors you will have to replace the front sensor as if it has tripped the light it is now U/S even if it looks OK they are only a few pounds from the main Stealers !!!!!!
-
eers guys.appreciate that.
-
changed the front pads on my mates 03 vectra 2.2 elite the other day and re-connected the sensor but the brake warning light is still illuminated....the rear pads are very low also but i was told the rears dont have wear sensors??? does the light need re-setting in some way or is it the rears showing now? many thanks guys.
Have you still got the old sensor(s)? Chop the (wheel) end off, strip the ends back & connect them together, & refit to the car. If the light goes out, your new sensors are damaged. :y :y