Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / crank speed sensor

« on: 19 October 2025, 10:20:23 »

Did a scan and fault code 31 (no speed signal) came up, it should show cranking speed on lie data so looks like the sensor has gone down. Drove fine on the way home but no go next morning. 97, 3L v6 so what is part number and where is best place to get a Bosch one?

2

Car Parts, bits For Sale & Wanted / few odd bits

« on: 08 September 2025, 17:48:56 »

Clear out time. Front and rear estate wiper motors, engine cooling fan ,aux water pump and ecu fan

3

Omega General Help / speedo/rpm per mph

« on: 16 July 2025, 19:44:00 »

I was wondering what the rpm against road speed is for a 3L , my speedo is out 5mph at 25 doing 30. 42 is 50. Checked against sat nav.

4

Omega General Help / Quick question

« on: 16 June 2025, 15:46:50 »

Live data says engine running lean, I know I can smell it. Bank1 and 2 say 128 when cold and 134 when hot what ever that is. Says rich if I rev it, no intake leaks I could find, idle speed spot on , temp gauge matches scanner and no exhaust leaks. Any ideas?

5

Omega Electrical and Audio Help / Further ABS fault

« on: 08 June 2025, 16:16:01 »

Okay so got my Snap On code reader working, it says fault code 35 pressure release relay fault. (same as Ds diagnostic tool) so does this mean it needs a rebuild? I take its not referring to the 2 50amp electrical relays on the top?

6

Omega Electrical and Audio Help / ABS code 35

« on: 03 May 2025, 18:23:13 »

Managed to get D to scan the ABS and it came up with 35 , does that mean the ECU is knackered? It has been sat 20+ years.

7

Omega Electrical and Audio Help / indicator switch

« on: 17 April 2025, 19:11:53 »

Any one bought an £11 indicator switch of evil bay? any good or do I get  Febi one at twice the price.

8

Omega Electrical and Audio Help / no spark

« on: 31 March 2025, 17:12:05 »

Fuel pump works but only when cranking, its so quite! Thought it might start but no sparks, now should the fuel pump prime when ign turned on for a few secs? Will put my Snap On scanner on it to see if any codes Wed.
 Also turned over for ages and oil light still on, any trick for priming system?

9

Omega Electrical and Audio Help / ECU and chip

« on: 25 March 2025, 16:53:37 »

Okay looks like I am stuck as chip and code NLA , will try local key person but might end up using after market ECU.

10

Car Parts, bits For Sale & Wanted / ECU and chip

« on: 25 March 2025, 16:51:17 »

Wanted urgently ECU for 3.0 V6 with immobilizer chip

11

Car Parts, bits For Sale & Wanted / wanted 1/2 shafts

« on: 21 February 2025, 16:35:02 »

Need 2 1/2 shafts , dont need the joints but what ever anyone has URGENT as Austin in show in April.

12

General Car Chat / 1.6 Zaff

« on: 04 April 2024, 14:16:20 »

Seeing how my youngest lad didnt keep his pants zipped up he now needs a 7 seater, got a text from him asking if a 2013 1.6 Zaffera was any good. Told him gutless but no worse that any of the choices for reliability . 88K he said for mileage.

13

Omega Electrical and Audio Help / Wots this plug for?

« on: 05 February 2024, 20:42:14 »

On the wiring loom section that goes to the Lambda sensors on the 3.0 there is a 2 pin plug . Did it go to the fuel vent valve? If so will it need a resistor to fool ECU?

14

Omega Electrical and Audio Help / engine ECU immobiliser.

« on: 29 January 2024, 19:54:26 »

So is it possible to deactivate the immobiliser in the engine ECU on a 96 3.0 V6 or is the only way by getting a key chip.

15

Omega General Help / propshaft damper

« on: 05 January 2024, 15:44:32 »

So went to fit the prop to the Austin and cant remember how the damper fits at gearbox end, one shown in Haynes did not have one and no mention. Now have seen on here? some do not have a damper so is it okay to leave it off?  Total PIA to get at when its on my scissor lift , good job it has a safety interlock as squeezed inside it to reach!!