Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Dan282]

Hi all. I'm currently trying to change the 2-3 soloniod. Does it does unclip from the wire and pull out or do u have to do anything else? Currently have gearbox sump and filter off.

Cheers

[steve6367]

un-plug the wire, remove the roll pin and then the solenoid will pull out.

When I did mine I could not remove roll pin and ended up removing the whole valve body.

I have pictures of it all in bits if you need them.

Steve

[serek]

 had replace 2 or 3 of them solenoids and all ways was problem with removing pins
imho its quicker replace gearbox

[steve6367]

If you have to drop the valve body - note the 2 ball bearings - do not drop them and lose them!



As Serek says, not hard to drop the box if you want to work on it on the bench - I thought I would not be able to do it, but managed it ok on the drive. Mine had a failed thrust washer so had to come off.

[Dan282]

All sorted thanks guys. I needed to get some mole grips on the pin and it came out reasonably easy in the end. Thanks