76
Omega Electrical and Audio Help / Re: MID from auto to a manual
« on: 25 November 2008, 09:08:25 »Quote
i need a new mid my replacement one has dead pixles anyone got a 3.0 one???
i have one from a 99 mv6 fella

Please check the Forum Guidelines at the top of the Newbie section
i need a new mid my replacement one has dead pixles anyone got a 3.0 one???
Dash works now - fuse 28 put back in
I think either later today or tomorrow I will trace the wire back to the boot.
What route does it take from the fuse panel to the LHS cable run?
QuoteRelay still clicks
i will say it again broken wire at the passenger side hinge ! had two of them now :-?
Relay still clicks
As an aside, you know those little RHD/LHD levers inside the headlights, which way should they be for RHD? I think one of my lamps may be the wrong way round
Humpy
Totally different how Markey?? Not had any problems doing this before mate...works fine...
Well I managed to get my old headlights apart earlier and took the plastic adjusters out (which are still intact) and I will be attempting to put them in my projectors at the weekend if not sooner. So the idea is to heat up the lens to soften the mastic goo and the lenses should then come apart with ease?
Paul
Sounds daft but mines an elite so can i fit the xenon type then mate cause the projectors are better than the older type but not as good a xenon ones.......All i have to do is fit them right or is there more to it than that. :-/ :-/Quoteas long as the car stays level when loaded up xenons are fine ! i have converted 3 cars now and never had a problem come mot time !!