Omega Help Area > Omega General Help
Diff bracket bolt help
addy:
Can anyone help me? I have got a replacement, diff for the 2ltr Omega. It didn't come with the front bracket. So I was going to use the bracket off the old diff I am taking off. I have read that the 3 bolts have to be replaced? I have looked everywhere for new ones, but can only find, ones removed from diffs in Russia. Can these bolts be reused, as from what I have read they are torqued and angle tightened? Or could a normal High tensile bolt, be used instead with some blue thread loc?
I have attached a picture to show the bolts I mean. Number 8 arrowed.
Thanks in advance for any help.
biggriffin:
Clean and reuse the old ones.
addy:
Thanks biggriffin, for the quick reply. Will some blue thread loc, be needed or just fit dry?
I thought I would ask as the Haynes manual, says renew bolts because of the angle settings.
Stage 1 90Nm
Stage 2 Tighten 45 degrees
Stage 3 Tighten 15 degrees
Nick W:
If you follow all of that, I suspect you'll be the first person ever to do it 8)
If I was paranoid about them, I'd use a torque wrench for the 90Nm before adding a bit more :y
addy:
Thanks both. Knew I would get a decent answer from this forum. :y
Navigation
[0] Message Index
[#] Next page
Go to full version