Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: 2woody on 02 April 2013, 22:17:40
-
anyone know how to identify one from the other when they're both off the car ?
-
may be from valve and cylinder bore size .. 3.0 must be bigger..
iirc 79.6 81.6 vs 86 mm
-
Is to not etched along the edge...?
Sure Daz showed me some pin punch markings on a flat near one of the corners. :-\
-
Its normaly engraved into a flat along the side.
Or measure the squish area volume.