Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Re: Omega B Estate 2003 Power Steering Pump

« on: 23 April 2024, 10:32:01 »

Got it and fits a treat. Thanks for help BG

2

Omega General Help / Re: Omega B Estate 2003 Power Steering Pump

« on: 28 March 2024, 18:53:40 »

Yes please, that sounds wonderful.
Please let me know the best way to pay you etc and contact you.
Thanks again for your help.
Tillers

3

Omega General Help / Re: Omega B Estate 2003 Power Steering Pump

« on: 28 March 2024, 08:30:03 »

Yes please, that sounds wonderful.
Please let me know the best way to pay you etc and contact you.
Thanks again for your help.
Tillers

4

Omega General Help / Re: Omega B Estate 2003 Power Steering Pump

« on: 27 March 2024, 15:58:56 »

That would be a real result. Fingers crossed. Thanks for help..

5

Omega General Help / Re: Omega B Estate 2003 Power Steering Pump

« on: 27 March 2024, 12:19:11 »

Yes of course, thanks for reply
Its is a 3.2 V6  Petrol.. Engine Type Y32SE/08769147        VIN:W0L0VBP3531118600

6

Omega General Help / Omega B Estate 2003 Power Steering Pump

« on: 27 March 2024, 10:20:58 »

I have been trying to get a replacement/refurb power steering pump for sometime with no success.
I purchased one that said it fits but it didnt.
The part number I have been told is correct is OEN 24436787.
The part number on the pump label is ZF 7691 955 313        CLIENT   24 436 397
The number on the back of the pump  is 91 128 at top and 89 at bottom.
I have though about getting it reconditioned but was quoted about £400
Any advice would be greatly appreciated.
Thanks Tillers

7

Omega Electrical and Audio Help / Re: Central Locking Control Unit 2003 3.2 Omega Estate

« on: 23 February 2024, 18:28:41 »

Thanks for help.

8

Omega Electrical and Audio Help / Re: Central Locking Control Unit 2003 3.2 Omega Estate

« on: 23 February 2024, 17:43:59 »

Thanks for advice, will check that out.

9

Omega Electrical and Audio Help / Central Locking Control Unit 2003 3.2 Omega Estate

« on: 23 February 2024, 15:22:43 »

Hi all,
Please can anyone advise where this unit is located, as i feel this may be the problem.
I have looked in the drivers footwell behind the fuse box area and cant see anything obvious.
I have an odd fault developed and when I open the drivers door it locks all the other 3 doors.
Sometimes when you lock the car the interior light does not go off.
Any advice much appreciated.
Tillers

10

Omega General Help / Re: Omega B 3.2 Exhaust Manifold Nuts. Drivers Side

« on: 25 July 2020, 15:48:43 »

M8, I used with spring washer and  washer.

Thanks for help much appreciated

11

Omega General Help / Re: Omega B 3.2 Exhaust Manifold Nuts. Drivers Side

« on: 25 July 2020, 15:47:19 »

They're M8, and you use a 13mm spanner/socket.
You can get new manifold nuts anywhere. When I did the headgaskets on mine, I replaced all the studs, nuts and downpipe nuts with new for £5 to give you some idea

Thanks for help much appreciated

12

Omega General Help / Re: Omega B 3.2 Exhaust Manifold Nuts. Drivers Side

« on: 25 July 2020, 15:46:35 »

M8. As I recall that might also be all metal self locking. The distorted thread type.

.

Thanks for help much appreciated

13

Omega General Help / Omega B 3.2 Exhaust Manifold Nuts. Drivers Side

« on: 25 July 2020, 13:32:56 »

Hi All,
I have to change my exhaust manifold drivers side and would like to replace the nuts securing it to the block.
Can anyone advise what size they are please..   M8/M10?
Regards
Tillers

14

Omega General Help / Re: Omega 3.2 Engine Management Light

« on: 08 June 2012, 08:50:48 »

Thanks for all the help.
Any advice on whats involved in moving the sensors ?


Regards
Tillers

15

Omega General Help / Re: Omega 3.2 Engine Management Light

« on: 07 June 2012, 18:54:40 »

Thans for advice much appreciated.
How difficult is to move the sensors.

My bet is P0430/0420 and the fix is to move the second O2 sensors to behind the main CATs rather than in front of them..