Omega Owners Forum
Omega Help Area => Omega Electrical and Audio Help => Topic started by: Nickffc on 12 September 2006, 23:09:27
-
ok....sorry if this has been covered..... i did look but could'nt find a post for it....so
fitting a bluetooth handsfree kit......... i have a ccr2006.... is there a radio mute cable on this unit?....... :-/
-
It should have, though i've got the 2013, so i can't say for sure which connection it is you need to make. :-/
Anyone else?
-
I believe it has for the external audio source function, but again, not sure where.
Have you had a look at the back of the unit?
Pg 17 of the audio manual describes how to adjust the volume of the external source, which implies there is an audio in and mute connection. Then it goes on to say that the external source should be installed by a dealer!
-
Hop the following is of use.
(http://i23.photobucket.com/albums/b394/Marks_DTM_Calib/FaceliftRadio.jpg)
The circuit diagram shows three connections in the top right, two are an audio feed and one is a select line.
The connector pin out is as follows:
(http://i23.photobucket.com/albums/b394/Marks_DTM_Calib/FaceliftConnector.jpg)
-
there may be a label on the top of your head unit, there was on mine. Pics are here (http://www.omegaowners.com/forum/YaBB.pl?num=1153589773/2#2) - when the phone is in use the GID shows "external audio". I believe there is a connector behind the glove box which is pre-wired for car kits and allows use of the front speakers and microphone in the courtesy light - although I didn't use that myself as I didn't know about it!!
-
not all cars are prewired, but if yous is (check for 16 pin connector taped up on top of glovebox), this is much easier than faffing around...
-
Usefull picture - I haven't got one - strange
-
cool.....thanks guys.... may take a stab at having a look after work monday.... not taken anything apart on this motor yet....!!!! only two weeks old....well to me anyway.......