Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: zirk on 29 February 2012, 18:08:19

Title: 03 3.2 fault code 1110
Post by: zirk on 29 February 2012, 18:08:19

As above P1110, Intake Manifold Valve 1 Voltage High/low/open.

So Im assuming Multi Ram solenoids??, take it Valve 1 and 2 relate to front and back, if so which is which, any common faults I should be looking for tomorrow.

Thanks Chris.

Title: Re: 03 3.2 fault code 1110
Post by: RobG on 29 February 2012, 18:42:04

Check connections to inlet manifold @ rear of plenum

Title: Re: 03 3.2 fault code 1110
Post by: zirk on 29 February 2012, 18:45:09

Thanks Rob :)

Title: Re: 03 3.2 fault code 1110
Post by: zirk on 01 March 2012, 00:55:43

Well had a quick look tonight with a good LED light, cant see or feel the connectors at the back, maybe fingers too fat, could see the front set up, no probs, wheres the connector?, under it? , left. right etc, will look again tomorrow.

Or go I need to remove Plenum?

:-\

Title: Re: 03 3.2 fault code 1110
Post by: Kevin Wood on 01 March 2012, 10:01:26

Rear passenger side of the plenum, right where the air con / brake servo pipe are routed behind the plenum, there should be a little black solenoid valve with a 2 pin connector on it.