Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: PAULCDX on 09 April 2012, 17:36:50
-
Hi all,
Recently purchased a replacement bootlid for my Omega saloon and was wondering how difficult it is to replace? Any wires need cutting or replacing?
If anybody has any pics or diagrams that would be fantastic :y
Thanks in advance :y
Paul
-
Undo torx holding inner grab handle. Pop off the retainers holding carpet on lid. Top L/H of lid (when open) through the cutout there`s a multi-connector. Release and pull cabling down through lid. Two bolts either side of lid, release the struts. Job done. I do it on me tod but it`s easier with a second pair of hands
-
Hi Rob,
Thanks for that, it doesn't sound to difficult even for someone like me ;D
I will give that a go, didn't even think to take the carpet off ::)
-
If you need a hand Mate then I have tools and
I do it on me tod but it`s easier with a second pair of hands
I have tools and a spare pair of hands if o/p gets stuck...
-
seem to remember they are heavy.
-
seem to remember they are heavy.
Not too bad I'd have thought... just easier to do the job with two people so as to lessen the risk of scratching any bodywork.
I've managed to remove two estate tailgates single handedly, well I used a pair, and I'm not exactly a body builder type!
-
seem to remember they are heavy.
Not too bad I'd have thought... just easier to do the job with two people so as to lessen the risk of scratching any bodywork.
I've managed to remove two estate tailgates single handedly, well I used a pair, and I'm not exactly a body builder type!
yeh balance em on your head & knock the pins out. took one off today.
-
Cheers Brikhead :y, how far are you from Wolvo mate?
If you wanna come over, make sure you come over in the Y reg MV6 so I can gloat over it lol ;D