Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: bluebuss on 15 May 2012, 09:27:55

Title: cruise control actuator.
Post by: bluebuss on 15 May 2012, 09:27:55

hi there again, need some more help. are these controllers all different part numbers?
trying to source one from ebay.... loads about but not to sure if they are all compatable..
dumb question maybe...but then we dont know it all do we....
help please, thank you, :-\

Title: Re: cruise control actuator.
Post by: RobG on 15 May 2012, 10:24:09

Actuators are the same. Bowden cables have two different lengths dependent on whether short or long plenum fitted on V6

Title: Re: cruise control actuator.
Post by: bluebuss on 15 May 2012, 10:29:48

thankyou, im going to fit it on my 2,0l. do you think a long or short cable should do??

Title: Re: cruise control actuator.
Post by: hotel21 on 15 May 2012, 13:00:45

Would suggest that the first thing to check is that there actually is wiring on the strut top to connect it to as I recall reading on here somewhere that the 2 litres were not always fitting with the required wiring for some reason.

Title: Re: cruise control actuator.
Post by: RobG on 15 May 2012, 13:13:26

Quote from: hotel21 on 15 May 2012, 13:00:45

Would suggest that the first thing to check is that there actually is wiring on the strut top to connect it to as I recall reading on here somewhere that the 2 litres were not always fitting with the required wiring for some reason.

Only the CDX spec had it fitted. If OP`s is a lower spec will also need the bracket on the throttle body (hens teeth)

Title: Re: cruise control actuator.
Post by: bluebuss on 15 May 2012, 16:51:30

thanks, its got the bracket on the throttle body with the hole for the cable and the wiring on the strut top....

Title: Re: cruise control actuator.
Post by: bluebuss on 15 May 2012, 16:57:35

 :y it is a vauxhall not an opel...its now registered in france :y