Right update on Silver Speedo Project are as follows
After collecting the Instrument panel from Serek(thank you) i had to remove the clear lens with cracking or damaging the surface which is a lot difficult than i thought after different approaches and failing e.g. saw, stanley knife, sharp nice, heat etc. i finally managed a succesfull way of getting off, granted it was the most risky but if i had just pulled it off it would have cracked left right and centre.
My Succesfull approach was this A tiny flat head screw driver and a tiny hammer, and basically had to pinpoint where the clear goes into the black plastic then hit the hammer to crack the lens all the way round if your careful it will just crack the tiny lipped section of Clear plastic which is what you want, so after doing this all the way round Tadaa!, Shes off, what you need to do then is line the clear lens up to the sprayed instrument panel and see where the jagged clear meets jagged black trim off to its sits flat and glue together with a decent plastic glue, (put some weight on top of the Instrument Panel whilst glue is drying so it forces the clear into the black)
If you are going to attempt it remember to put the TID/MID clock buttons back in ;D ;D :D :D
(http://s8.postimage.org/tj8ejyolh/IMAG0271.jpg)
(http://s16.postimage.org/yz3bdmkrp/IMAG0272.jpg)
(http://s16.postimage.org/lanbbzov9/IMAG0273.jpg)
(http://s16.postimage.org/ovj6v7tet/IMAG0274.jpg)
Im Now going to remove my existing Clocks to fit to the Silver then ill update with a picture once fully fitted to the Miggy!! :y