Omega Owners Forum
Newbie Area => Newbie Welcome Area => Topic started by: ob one on 08 July 2012, 10:59:34
-
Hi, newbie here.
Just had mot done on my 2.2 on sat, failed on emissions as they are two high. Can any one point me in the right direct re O2 sensors and whether they are 2 or 4 wires The car is a 2002 2.2 saloon. Also failed on the following
Excess play o/s rear suspension arm bush/pin
rear break binding
nearside front to back break pipe excessively corroded.
Cars only done 90k and to good to scrap. Any pointers on cost for all this. :-[
just woundering what best to do with it. :y
-
If you look under the bonnet ...follow the exhaust manifold down you will see the sensor very easily...the same applies to the one under the car where the cat is..can be seen very easily...mine are 4 wires on my 2.2,, :y
-
personally if mine failed on those bits only i would not hesitate to get it done,after all it is not a big deal for a years motoring :y
-
thanks for the reply,
got quoted £90 for the sensor. So bricking my self for the rest of the parts, let alone labour. Are these big or just simple enough jobs. the chap nxt door said the suspension arm bush is a big job. needless to say I'm no mechanic.
cheers
-
How do you do OB, welcome. :y
Post your questions over on the General Help board - more people will see them.
-
Hello and welcome to OOF :y
-
hi & welcome :y
-
I am sure there are guys on here would do the jobs far cheaper and possibly better than your normal garage :y
-
How do & welcome along :y :y
-
Welcome to oof
-
Welcome to oof :y
-
Welcome to oof :y
-
Welcome to ooforum 8)
-
Welcome to OOF mate :y
-
welcome to the forum. :y
-
Welcome bud! :y
-
Hello and Welcome! Post your questions & queries in the General Help Section you'll get more replies as this is the place to just say How Do? ;) :y
-
Welcome and Phil is right best put your questions in the general help area :)
-
Welcome to OOF.
-
Hello welcome to the Forum :y
-
Welcome aboard mate :)
Any news on sorting your mig?