Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: jonny2112 on 01 October 2012, 11:45:09

Title: Inlet manifold removal
Post by: jonny2112 on 01 October 2012, 11:45:09

Started to strip down for a cam cover gasket and stat change, but cant see how to disconnect the injector loom  to remove the manifold.

Sorry guys, but didn't want to mess about too much, so any help much appreciated.

Title: Re: Inlet manifold removal
Post by: albitz on 01 October 2012, 11:58:18

Big electrical connector at the rear of the manifold Jonny. :y
If you cant find it I will take a pic and post it here. ;)

Title: Re: Inlet manifold removal
Post by: amba on 01 October 2012, 12:02:16

Once electrical connecter is undone along with the securing bolts,it requires a bit of manouvering around to get it clear.

Pull forward towards front of engine to allow the edges of manifold to clear then lift o/s edge up to clear and remove.Its a tight fit but will come away,but only in the right place

Title: Re: Inlet manifold removal
Post by: tunnie on 01 October 2012, 12:03:06

There are numbers on top of the manifold for the pots, on some black plastic. Follow this back to the bulkhead, under the scuttle as Albs says there is a big connector  :y

Title: Re: Inlet manifold removal
Post by: jonny2112 on 01 October 2012, 12:13:30

Cheers guys. Thank you very much indeed. I didn't see it 'buried' away in the back  :-[