Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: greenman on 07 November 2012, 17:29:43
-
Comes on.Stop.Restart goes off.
Comes on again.Seems to be after running at a steady speed
Car runs fine
No codes showing.
-
What engine? ???
-
I believe a code will be stored after the EML is illuminated for 30 seconds or more.
Are you sure it is the EML? How are you reading the codes (or lack of)?
-
2.2 engine
mechanic mate tried the codes
definitly been on for more than 30 secs.
-
There is a code there. Find another mate with a better reader :P
-
paperclip / pedal test ? or doesnt that work on this car ?
-
paperclip / pedal test ? or doesnt that work on this car ?
Not on 2.2
-
ahh, im still learning ya see :D
weve got a code reader at work, its a mid level one that we got from the tool delivery guy. does most cars, apparently.
-
You seam to be having a similar problem to me,I have just put a EML topic up on the board,what have you been replacing.
-
Never, ever, ever, EVER just change parts on a hunch. Ever.
:y
-
Got it read again today with a good reader
No codes stored
eml did,nt come on.Only short journeys
-
OK, back to basics, describe the light :-[
-
Car with spanner thru it
As I said if I stop and restart light goes out
-
Can you PM me reg no, something I need to check
-
There is a code there. Find another mate with a better reader :P
Not hijacking this but I`ve had the "spanner" light come on about 4 times in the past month and when putting my reader (Maxscan) on it, comes up with no codes stored or pending ???
-
There is a code there. Find another mate with a better reader :P
Not hijacking this but I`ve had the "spanner" light come on about 4 times in the past month and when putting my reader (Maxscan) on it, comes up with no codes stored or pending ???
Are we talking petrol or The Devil's fuel? Sister-in-laws diseasal Astra had the EML light on (spanner through car :-\) I tried my Maxscan & that showed the same ie no codes stored or pending, however the pedal trick showed a code (glow plug) :y
-
Hmmmm, its defo a 2.2 petrol auto CD. I was clutching at straws.
I'm at a bit of a loss on this one. If you were closer to me, I'd get you to swing by...
-
There is a code there. Find another mate with a better reader :P
Not hijacking this but I`ve had the "spanner" light come on about 4 times in the past month and when putting my reader (Maxscan) on it, comes up with no codes stored or pending ???
Are we talking petrol or The Devil's fuel? Sister-in-laws diseasal Astra had the EML light on (spanner through car :-\) I tried my Maxscan & that showed the same ie no codes stored or pending, however the pedal trick showed a code (glow plug) :y
:)
-
Thanks for the help.
I,ll run it till the eml comes on and get it
read while it,s on(maybe show up then)
I,ll give you an update.
-
Update.
No light on for 3 days(200 miles).
Did notice light goes out after ignition on(as it should).
previously the eml was staying on until engine started
?????????????
-
Hi,
I`ve had this problem for ages and I think I`ve sust it,I put an after market cat on and that`s when the problem started, I `m going to run the car till the exhaust fails then replace it with a genuine cat.