Omega Owners Forum
Chat Area => General Car Chat => Topic started by: Auto Addict on 05 January 2013, 09:56:37
-
Bought a set, they're shiny black.
Any do's and don'ts as regards painting them?
-
I have a painted set on clit.. a normal thickness paint dont make any problem..
however, if the car is dark color no painting required imo..
-
I have a painted set on clit.. a normal thickness paint dont make any problem..
however, if the car is dark color no painting required imo..
Got to change them to silver lake.
-
I thought I would rub them down with some 1200 wet & dry, thin coat of plastic primar.
2 thin coats of Silver Lake, 1 coat of laquer.
-
I used a kitchen scourer on my pattern ones. That said, one has now pitted.
-
I used a kitchen scourer on my pattern ones. That said, one has now pitted.
Yes, did the same on my old ones, and hand painted them.
Problem was the paint went on a bit thick.
-
I sprayed mine - mounted them all in some card, and sprayed one "swipe" at a time, about 5 coats IIRC (it was a long time ago).
-
I mounted card, with sensors mounted, it a ice cream tub, and put the lid on after every spray, to keep dust out.
-
Probably best done indoors as well if possible, if only to minimise the temperature and humidity issues of our delightful weather :y
-
Probably best done indoors as well if possible, if only to minimise the temperature and humidity issues of our delightful weather :y
:y
-
Done it many times.
I just cleaned them using diluted APC ( all purpose cleaner ) and allowed to dry off thoroughly .
Get a small box and use the hole cutter supplied to cut four holes in it to mount the sensors for painting . Let them sit about 6mm proud of the surface to ensure paint covers all the sensor.
Paint them in a warm enviorment best about 18 degrees at least . As suggested a light covering of white primer and then two or three "mist " colour coats until you get coverage , dont put too much paint on them. . Allow to cure /dry and then three or four " mist " coats of lacquer . Best tip I can give you is use good lacquer . When using aerosols I always use U pol clear No 1 which has never let me down . You can flat the lacquer down and polish if required using 1500 wet & dry if neccessary but you probably won't have to . Again allow the lacquer to cure by leaving them in the cardbox on top of the HW tank for 12-18 hours .