Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: SMD on 21 April 2013, 12:20:54
-
Breather bridge to plenum seal and breather bridge to throttle o-rings?
I have everything else and forgot to get these :( They were replaced last year
-
O rings should be fine,but I always tend to replace the "top-hat" breather box to plenum seal ,but just have a good check to ensure its not split and hasnt started to perish .
Best removed to clean as most rubber seals don,t like carb-cleaner,then just freshen them up with a wipe of grease to get them supple again :y
-
I use silcone grease on O rings.
-
Breather bridge to plenum seal and breather bridge to throttle o-rings?
I have everything else and forgot to get these :( They were replaced last year
I usually replace these but yours likely to be reusable after only 1 year "wear" :y
-
Thanks for the replies. I know they cost peanuts but the local Saab dealer where I bought service items from previously closed down and andyc is difficult to get hold of at the moment. I ordered a couple of filters from him (but forgot these) only last week after trying to get hold of him for a week. :(