Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Shackeng on 10 May 2013, 19:47:19
-
MOT tomorrow and just discovered inop headlamp washer jets both sides. Any quick checks to carry out? :-\
-
MOT tomorrow and just discovered inop headlamp washer jets both sides. Any quick checks to carry out? :-\
Green fuse next to relay in box by battery, if OK, stick 12V to pump
(http://i190.photobucket.com/albums/z257/belisensis/Headlampwasherrelay-1.jpg) (http://s190.photobucket.com/user/belisensis/media/Headlampwasherrelay-1.jpg.html)
-
Thanks Rob
-
If pump is knackered, remove jets prior to MOT then tester cannot issue a failure :D
-
If pump is knackered, remove jets prior to MOT then tester cannot issue a failure :D
Right, pump is off, and works with independent 12v applied, but did not work from stalk switch. I can only see a fuse 26 10A for it, but as the number plate lamp works on the same fuse, what next? I can only assume it is the wiring. Does the bumper have to come off for jet removal? Also I've just seen a comment that if car has factory fitted HID's it must have working washer jets. ??? ??? ???
Might be a solution to solder a link from the main washer pump feed. :-\
-
Did you make sure the lights were ON when you tried, hope I don't sound condescending but it's the little things we forget sometimes.
-
It only works with the headlights switched on ::)
Apologies for shouting, but you might pull all your hair out for nothing ;D
-
Must type faster :P
-
Did you make sure the lights were ON when you tried, hope I don't sound condescending but it's the little things we forget sometimes.
I wondered when you'd spot that Pike!!! :-[ :-[ :-[
Thanks very much Curt, its amazing what I'm still learning about this car, and I've had it 2 years.
Only working with the lights on makes sense, as Page 16 of my manual states, which of course I've never read.
Thanks again Curt, at least I can take it in for the MOT now. :y :y :y
-
Thanks for all the helpful replies. OOF working as it should, in an emergency, and quickly. Great job guys, thanks again. :y :y :y
-
::)
Good luck :y
-
The word you were all looking for is " PLONKER". :-[ :-[ :-[ :) :y
-
No problem, hope it passes. :y
-
Yes thanks, passed with two advisories, front bushes worn - to be poly'd soon, and one rear disc slightly rusty. :y :y :y
-
Job jobbed then 8)
-
Job jobbed then 8)
I think you mean 'non-job' jobbed Al!!! ::) ::) ::) :y