Omega Owners Forum
Chat Area => General Discussion Area => Topic started by: aaronjb on 07 June 2013, 11:00:45
-
Watching videos on youtube about machining things and this came up..
http://www.youtube.com/watch?v=IQ5Fu7TYuGQ
Mind those fingers! ;D
-
I was wincing expecting fingers to fly off ::) ;D Off to the shed to construct something better ;D
-
:o :o
-
No different to a bench grinder, I thought.... Tbh. :-\
-
True, although you don't usually use wire wheels in those - and they spin quite a bit more slowly I think..
After more time watching workshop videos I now want one of these: http://www.youtube.com/watch?v=P5Tu_zoO828
-
True, although you don't usually use wire wheels in those - and they spin quite a bit more slowly I think..
After more time watching workshop videos I now want one of these: http://www.youtube.com/watch?v=P5Tu_zoO828
Most excellent :) Amazing what goes on in sheds :D
-
And here are some more to be going on with :) http://www.youtube.com/watch?v=hLo1fFyi5wM
-
Cripes .. the spot welders scare me just looking at them! ;D
-
Can't see much wrong with that except it is a low powered model. ;D ;D
My next door neighbour had a large stone cutting disc explode and tore his jeans off his legs. No blood. He was a very lucky. I suspect he had been side loading his disc. I only ever buy discs out of boxes. I have seen people drop them in DIY stores.
-
Can't see much wrong with that except it is a low powered model. ;D ;D
My next door neighbour had a large stone cutting disc explode and tore his jeans off his legs. No blood. He was a very lucky. I suspect he had been side loading his disc. I only ever buy discs out of boxes. I have seen people drop them in DIY stores.
;D ;D
Yes they make a mess ...goggles are a must ::)