Omega Owners Forum

Chat Area => General Car Chat => Topic started by: omega3000 on 27 September 2013, 07:19:16

Title: Front roll bar bushes ?
Post by: omega3000 on 27 September 2013, 07:19:16
I need to replace my front anti roll bar bushes on vectra b . Ive heard to loosen subframe but surely there is an easier way  :-\
Title: Re: Front roll bar bushes ?
Post by: Lazydocker on 27 September 2013, 08:10:00
Iirc the official method is to take the engine out :o ::)
Title: Re: Front roll bar bushes ?
Post by: Marks DTM Calib on 27 September 2013, 08:20:13
The offical way is to remove the subframe but it can be done by loosening it
Title: Re: Front roll bar bushes ?
Post by: omega3000 on 27 September 2013, 08:41:18
Iirc the official method is to take the engine out :o ::)

 :'(

The offical way is to remove the subframe but it can be done by loosening it

I can see or just about get a ratchet spanner onto the front bolts but rear bolt looks tricky especially the drivers side . If i can loosen them maybe i can slide the new ones in with a bit of washing up liquid  :(
Title: Re: Front roll bar bushes ?
Post by: 05omegav6 on 27 September 2013, 10:58:46
You could just wait until you drop the 3.2 in ::)
Title: Re: Front roll bar bushes ?
Post by: omega3000 on 27 September 2013, 20:46:04
You could just wait until you drop the 3.2 in ::)

 ;D :P

Well managed to get them out no problemo . Only trouble is the new bushes didnt fit  >:( Being an SRI its got uprated 20mm ones instead of the feeble 16-18s ::)