Omega Owners Forum

Chat Area => General Car Chat => Topic started by: mcd840 on 03 June 2014, 22:49:56

Title: vec b dti issue after front springs changed
Post by: mcd840 on 03 June 2014, 22:49:56
as above, got a few jobs done last sat at the garage i normally use, just for mot time coming up, front springs, inner cv boot and steering rack boots. sat night i noticed when going over speed bumps in asda a strange "banging" spring sort of noise from pass side - the spring end doesnt seem to be sitting hard against the tooth bit in the seat on the shocky, not sure if thats any consequence ? and a knocking from the driver side which i can feel and hear when driving at lower speeds (its almost the exact same to the issue i had about 2 months ago which was the pass side track rod end).

any suggestions

cheers
Title: Re: vec b dti issue after front springs changed
Post by: chrisgixer on 03 June 2014, 23:00:22
Good place to start then. :y
Title: Re: vec b dti issue after front springs changed
Post by: Marks DTM Calib on 04 June 2014, 10:13:52
Check the spring clamp nuts are tight at the top of the strutt (you will need to remove the retaining plate nut and plate to get to them)