Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: hawke113a on 07 August 2014, 15:04:53
-
the wife was driving the car today and the heater matrix has gone...spraying water all over her feet....what would cause this to happen...i have suspected the head gaskets are on their way out....i had the water pump done two weeks ago....and i have noticed she is using loads of water....i need to sort this asap as the wife is using the car for work.....
-
What engine bud ?
-
Have you used radweld previously? Don't use any more if you have, and don't use any if you haven't...
Quick fix, disconnected the heater pipes at the bulkhead and join with a short length of copper pipe.
This bypasses the heater completely :y
Setting the temp to Lo will stem the flow, but bypassing it with the pipe is better. You then have until October to replace the matrix :y
-
its a 2.5 v6.....i thought about bypassing it but its what caused the pressure build up in the first place.....
-
its a 2.5 v6.....i thought about bypassing it but its what caused the pressure build up in the first place.....
getting hot in in a contained system ....... ;)
-
lol andy..... :D
-
Could just be corrosion caused by shoddy coolant maintenance... Coolant is always under pressure when the engine is running regardless of temperature as the water pump is always spinning. The new pump might have tipped a weak matrix over the edge. Oil cooler is probably not too far behind :-\
-
oh fan bloody tastic......im getting fed up with throwing money at the car....
-
Neither is insurmountable, and both diyable if you're handy with the spanners :y
You could leave the oil cooler until it fails, but if the system is neglected enough to blow the heater matrix, then I wouldn't trust it for long... Besides it's easier to deal with before it fills the engine with muck...
-
Did you check the main rad to see if it was getting warm all over ???
-
yeah ive had no overheating problems....rad and hoses all ok.....seriously considering getting rid
-
Either way you will have to fix the matrix or its going to be hard to sell unless you want peanuts for it :( Worth fixing though imo :y
-
yeah i suppose ya right...its just a ball ache :-\
-
Easy enough job if you take the "short cut" method - matrix cheap enough, less than £20 ;)
-
Easy enough job if you take the "short cut" method - matrix cheap enough, less than £20 ;)
Seen the guide once but cannot now find it. :-\ :-\
-
i had a look at the shortcut method yesterday....has anyone got the link for it...save me searching thru all the posts again
-
http://www.omegaowners.com/forum/index.php?topic=90621.0
-
oh dear...looks a little tricky....hate jobs like this....oh well :-[
-
oh dear...looks a little tricky....hate jobs like this....oh well :-[
Is there no one near that could help you , maybe someone on here :-\