Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: ckz on 07 September 2014, 11:38:09

Title: Load cover estate help, urgent please
Post by: ckz on 07 September 2014, 11:38:09
Hi guys,
How can I get the load cover to?
Omega CDX estate. 2000 reg.
I can shift it forwards and backwards but no idea how to get it out.
Please help
Title: Re: Load cover estate help, urgent please
Post by: tigers_gonads on 07 September 2014, 11:48:01
If its a pre / mini facelift, i've got one here  :)
Pm me  :y
Title: Re: Load cover estate help, urgent please
Post by: ckz on 07 September 2014, 12:05:37
Sorry, wrong formulated.
I need to get it out.
I have one but don't know how to remove it. Lol

It's facelift.
Title: Re: Load cover estate help, urgent please
Post by: pauls on 07 September 2014, 12:36:16
If you want to remove it. On the runners towards the back of the car is two pieces one on each side that can be removed. Stick your finger in the runner part and you will feel a switch to push then you just lift up and out it pops. Then you just pull the cover out.
Title: Re: Load cover estate help, urgent please
Post by: ckz on 07 September 2014, 13:47:40
Done.
Thanks for the help
Title: Re: Load cover estate help, urgent please
Post by: zirk on 07 September 2014, 15:14:34
They come out a lot easier than they go back in.  ;D ;)
Title: Re: Load cover estate help, urgent please
Post by: YZ250 on 07 September 2014, 16:41:56
I realise that you've already done it but in future, if you slide the complete cover to the rear, pull sharply backwards while tilting the front up, and not only should it come out by automatically releasing the locking tabs but it should also lock it back together so that the runners don't fall out when you remove it.
When you refit it, tilt the back end in first and then push the front down.  :y
Title: Re: Load cover estate help, urgent please
Post by: 05omegav6 on 07 September 2014, 23:18:17
I realise that you've already done it but in future, if you slide the complete cover to the rear, pull sharply backwards while tilting the front up, and not only should it come out by automatically releasing the locking tabs but it should also lock it back together so that the runners don't fall out when you remove it.
When you refit it, tilt the back end in first and then push the front down.  :y
Oddly enough, that's what the manual says... ::)