Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: mantaray on 11 September 2014, 12:34:57

Title: 2.5 TD , bubbleing around injector base?
Post by: mantaray on 11 September 2014, 12:34:57

Had to replace the leak of pipes on the omega yesterday, I noticed that with the engine running there was bubbleing in the spilt fuel around the injectors where they sit in the head. I am hoping that it is just a case of nipping them down in the head, but was wondering if any one has had the same problem.

Title: Re: 2.5 TD , bubbleing around injector base?
Post by: 05omegav6 on 11 September 2014, 13:19:31

Sounds like failing injector seals :-\

Title: Re: 2.5 TD , bubbleing around injector base?
Post by: Marks DTM Calib on 11 September 2014, 13:22:50

Try nipping up as a starter or replace the injector seal on that injector (or if you are really stuck then re-anneal the copper washer and refit)

Title: Re: 2.5 TD , bubbleing around injector base?
Post by: TheBoy on 12 September 2014, 09:17:52

Hope its not the one with the piezo in, as that can be a bugger to remove  :'( :'(. No4 from memory.

Title: Re: 2.5 TD , bubbleing around injector base?
Post by: mantaray on 12 September 2014, 09:55:45

Thanks for advice.

It is 1 & 2 injectors that are the problem as far as I can see, but if replacing the seals on those 2 I will probable do all of them anyway. the car has done 175000 mile so probable need them all doing.