Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: V6 Matt on 10 March 2015, 21:06:48

Title: 3.0 rebuild cam question.
Post by: V6 Matt on 10 March 2015, 21:06:48

Hi all, I'm in the middle of rebuilding a 3.0 and have run into a problem.  I have 3.2 cams going back in but in unsure as to how to replace the cam wheels/pulleys.  Obviously the ones with the thicker coller go on the front bank ( or right bank for the omega) but which hole does the metal dowel go on the pully,1/2 and 3/4.
Hopefully this makes sense to someone who knows there v6's.

Title: Re: 3.0 rebuild cam question.
Post by: Matchless on 10 March 2015, 22:02:55

The cams are numbered 1-4 from left to right.
No1 cam uses No1 hole, No 2, No2 hole etc.

Title: Re: 3.0 rebuild cam question.
Post by: serek on 10 March 2015, 23:14:42

have look here
http://www.omegaowners.com/forum/index.php?topic=90500.0

Title: Re: 3.0 rebuild cam question.
Post by: V6 Matt on 11 March 2015, 07:47:47

Thanks chaps.  I was told that the G cam was the exhaust one and the J was inlet? 

Title: Re: 3.0 rebuild cam question.
Post by: serek on 11 March 2015, 22:55:19

Quote from: V6 Matt on 11 March 2015, 07:47:47

Thanks chaps. I was told that the G cam was the exhaust one and the J was inlet?

answer was in link above

Title: Re: 3.0 rebuild cam question.
Post by: V6 Matt on 12 March 2015, 06:42:17

I saw that, I just wanted to triple check as it doesn't mention J cams.

Title: Re: 3.0 rebuild cam question.
Post by: serek on 12 March 2015, 09:04:36

G cams intake
J cams exhaust

Title: Re: 3.0 rebuild cam question.
Post by: V6 Matt on 12 March 2015, 12:47:31

Thanms for the help.  :)