Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: 78bex on 08 August 2015, 00:21:16
-
but it`s started looking a tad perished
(http://dl.dropbox.com/s/3fv5caa508k8bdj/PICT0034s.jpg?dl=0)
The pipe runs along the top of the offside chassis rail in the engine compartment That jubilee clip doesn`t look right either.
maybe I can cut it back past the rotten bit :-\
-
Transmission to oil cooler pipes.Both mine have jubilee clips.Should be ok to cut bad bit out as long as there is enough spare will lose some transmission oil though.
-
Silly suggestion?
To avoid losing ATF, if there's enough slack in the hose, loosen the jubilee clip and push the hose as far onto the pipe as possible and re-tighten the jubilee clip? Then just ignore the bad end of the hose.....
Ron.
-
Silly suggestion?
To avoid losing ATF, if there's enough slack in the hose, loosen the jubilee clip and push the hose as far onto the pipe as possible and re-tighten the jubilee clip? Then just ignore the bad end of the hose.....
Ron.
Fixed it - cheers Ron :y