Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Webby the Bear on 16 December 2015, 20:25:21
-
Evening guys, hope you're all well :)
Got the check engine light come on about 20 miles from home today ::) I had a paperclip and the internet so I managed to get the codes :y
31 - EGR voltage low
133 - intake valve 2 voltage low
Luckily I think I have the answer.
I replaced my aux belt tensioner at the weekend. Being a ham-fisted oaf I broke the part that covers the wiring loom at the side that slides out...
Assuming ''intake valve 2'' is the front multiram valve and the wiring for the EGR meets in this loom I'm going to say that by not being able to put this piece of plastic cover back I've left the wires exposed to heat and these two have melted/broken??? Therefore, remove the loom tray, track the wiring, solder if necessary, get a new cover!
Unless theres something you think ive missed that's obvious? :)
-
ps, I looked at the front multiram and blipped the throttle.... nothing moved! :y
-
Check where its near aux belt :)
-
will do mate.
hopefully its an easy solder repair. :y
I take it ''valve 2'' is the front 'ram'?
-
code 57 is rear one... ...that I always forget to reconnect ;D
-
::) ;D
ill cable tie them back until I can repair it tomorrow.
don't suppose you have a spare plastic piece that slides in (you know what I mean lol) that I can buy off you do you?
if not im sure we've got some wiring shroud and plenty of cable ties at the shop :y
-
Note to self. Make sure multi RAM plugged in before removing wiring loom and inspecting it all ::)
Check engine light now out :y
Just a quick question though. The front ram. Is this the one that opens after 5k rpm blip? Blipped throttle a few times but didn't move. Car seems just as powerful :y
-
Note to self. Make sure multi RAM plugged in before removing wiring loom and inspecting it all ::)
Check engine light now out :y
Just a quick question though. The front ram. Is this the one that opens after 5k rpm blip? Blipped throttle a few times but didn't move. Car seems just as powerful :y
anyone?
-
Note to self. Make sure multi RAM plugged in before removing wiring loom and inspecting it all ::)
Check engine light now out :y
Just a quick question though. The front ram. Is this the one that opens after 5k rpm blip? Blipped throttle a few times but didn't move. Car seems just as powerful :y
anyone?
Should actuate around the 4K mark
-
Cheers Robeena :y