Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: EMD on 19 April 2016, 10:51:59
-
As my first fl Im looking at the engine rad and between that and the ac rad
is a small rad ??? Is that oil cooler ??? Very different from my pf car .
What's the score , what's needed to be undone to get the engine rad out
and Will i lose any refrigerent :-\
-
As my first fl Im looking at the engine rad and between that and the ac rad
is a small rad ??? Is that oil cooler ??? Very different from my pf car .
What's the score , what's needed to be undone to get the engine rad out
and Will i lose any refrigerent :-\
on 2.6 and 3.2 you got external gearbox cooler , that what is on you car
-
Its the transmission fluid cooler. On earlier cars it was built into the side of the coolant radiator. :y
Edit. Beaten to it by 29 seconds. ;D
-
Ah i see :y Looks like that trans cooler lifts out with the rad then and also
looks like a different set up of pipes to the ac so won't lose any refrigerent.
-
Thought it was all good until i noticed a coolant drip from underneath again :( Top sensor is weeping >:( I did put some ptfe tape on the thread and made sure it was tight but i think the copper washer is the priblem . Cleaned it up and put some sealant on so hopefully that will do it ::)