Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: amazonian on 28 June 2016, 11:45:11

Title: geometry settings
Post by: amazonian on 28 June 2016, 11:45:11

Are these correct chaps?

 1°10" front camber
                     0°05" front toe

                     1°45" rear camber
                     0°06" rear toe
                     0° thrust angle

 :)

Title: Re: geometry settings
Post by: tigers_gonads on 28 June 2016, 11:50:58

Front end

Camber -1.10 / -1.15
Castor 5 degree's
Toe in  0 degree 05

Move the subframe to adjust castor

Rear end

Rear camber 1 degree 30
Toe in 0 degree 05
Thrust angle MUST BE ZERO

Title: Re: geometry settings
Post by: Doctor Gollum on 28 June 2016, 14:40:25

Quote from: tigers_gonads on 28 June 2016, 11:50:58

Front end

Camber -1.10 / -1.15
Castor 5 degree's
Toe in  0 degree 05

Move the subframe to adjust castor(good luck actually persuading the garage to do this...)

Rear end

Thrust angle MUST BE ZERO

Fixed :y

Title: Re: geometry settings
Post by: Nick W on 28 June 2016, 15:30:48

Quote from: Doctor Gollum on 28 June 2016, 14:40:25

Quote from: tigers_gonads on 28 June 2016, 11:50:58

Front end

Camber -1.10 / -1.15
Castor 5 degree's
Toe in  0 degree 05

Move the subframe to adjust castor(good luck actually persuading the garage to do this...)

Rear end

Thrust angle MUST BE ZERO

Fixed :y

Agreed, especially as many won't adjust the camber, which takes a couple of minutes per side with two spanners.