Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: grifter on 22 May 2017, 18:23:08

Title: Torque settings inlet manifold 2.6
Post by: grifter on 22 May 2017, 18:23:08

Hi, I checked the change gasket/clean plenum guide thinking one of them would have values for this, from the settings given I couldn't see anything about torque settings for the inlet manifold bridge, unless reading it wrong, I wouldn't imagine it was 8nm, but again I don't really know. The 6 torx bolts is the value I'm looking for.

http://www.omegaowners.com/forum/index.php?topic=90653.0

Below is what I could find. It's not 8nm is it? :)
:

Torque Values
EGR pipe to EGR valve 25Nm
Item   Value
Plenum to inlet   8Nm
Support bracket to EGR valve 20Nm
Cable tray to plenum   6Nm
Throttle body to plenum   8Nm
Breather bridge to plenum   8Nm


Cheers

G

Title: Re: Torque settings inlet manifold 2.6
Post by: Doctor Gollum on 22 May 2017, 18:56:37

Where did those numbers come from ???

Title: Re: Torque settings inlet manifold 2.6
Post by: grifter on 22 May 2017, 19:37:25

Quote from: Doctor Gollum on 22 May 2017, 18:56:37

Where did those numbers come from ???

Link in first post

Title: Re: Torque settings inlet manifold 2.6
Post by: YZ250 on 22 May 2017, 19:43:34

Is it not in this lot?  :)

http://www.omegaowners.com/forum/index.php?topic=90519.0

Title: Re: Torque settings inlet manifold 2.6
Post by: Doctor Gollum on 22 May 2017, 20:11:10

Quote from: YZ250 on 22 May 2017, 19:43:34

Is it not in this lot?  :)

http://www.omegaowners.com/forum/index.php?topic=90519.0

Fancy that :D

Title: Re: Torque settings inlet manifold 2.6
Post by: grifter on 22 May 2017, 20:17:48

Quote from: YZ250 on 22 May 2017, 19:43:34

Is it not in this lot?  :)

http://www.omegaowners.com/forum/index.php?topic=90519.0

Now that is what I'm torquing about!

Intake bridge to intake flange - 20nm