Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: laney101 on 23 May 2017, 18:08:49

Title: Plug where does it go
Post by: laney101 on 23 May 2017, 18:08:49

Need help 3 pin plug at back of engine can't find what it connects to it by injector loom plug

Title: Re: Plug where does it go
Post by: laney101 on 23 May 2017, 18:31:14

(http://i747.photobucket.com/albums/xx112/laney1812/IMAG0140.jpg)[/URL]

Title: Re: Plug where does it go
Post by: biggriffin on 23 May 2017, 18:41:21

Looks like crank sensor.

Title: Re: Plug where does it go
Post by: TheBoy on 23 May 2017, 18:47:36

Yes, looks like crank sensor.  Loom comes out of cable tray at the rear, then you get the plug, then it runs down back of engine clipped to oil pipe.

Very often, on cranksensor replacement, the cranksenor cable may come up by abs pump over to cable tray.


So if its had replacement cranksensor, this may be the old one, never removed due to difficulty in removing old one

Title: Re: Plug where does it go
Post by: tunnie on 23 May 2017, 19:06:02

Yes think you will find you have two of those, last crank sensor loom was not removed.  :)

Title: Re: Plug where does it go
Post by: laney101 on 23 May 2017, 19:20:17

Gonna say I've not disconnected crank sensor I was doing thermostat hbv and temp switch just putting all back together and was like err where does this go