Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: frostbite on 23 June 2017, 15:43:03

Title: Obd pin out
Post by: frostbite on 23 June 2017, 15:43:03

I made a code flasher for my volvo 850, I need to know if the pin out is the same so I dont blow it up

(http://i218.photobucket.com/albums/cc244/frstbte01/Volvo/20170504_163152.jpg)
(http://i218.photobucket.com/albums/cc244/frstbte01/Volvo/20170504_163208.jpg)

My plan was to add a 3 way slider switch  to swap  moduals

Title: Re: Obd pin out
Post by: Doctor Gollum on 23 June 2017, 20:03:39

Given your car is NOT OBD compliant, you might be lucky. Then again...

Title: Re: Obd pin out
Post by: frostbite on 23 June 2017, 20:47:44

What could be the worst that could happen?

I have this set to the engine but with the slider will hopefully flash the climate and gearbox

Bit I need to know which pin does what, I will try and find the volvo pin out again

Title: Re: Obd pin out
Post by: Doctor Gollum on 23 June 2017, 21:00:30

Being a 'classic', Haynes will tell you...

Title: Re: Obd pin out
Post by: TheBoy on 24 June 2017, 09:40:52

Why not just use a paperclip. Pretty certain the 2.0l doesn't flash out to the (non) OBDII port, as it flashes to the dash instead.

Look up Paperclip test

Title: Re: Obd pin out
Post by: frostbite on 24 June 2017, 17:08:18

That was the point with the 850, but if it wont work I wont bother, I know the pedal trick works but this flashes slower and each code is flashed by pressing the button