Omega Owners Forum

Chat Area => General Discussion Area => Topic started by: JamesV6CDX on 25 September 2008, 16:42:30

Title: Exhausts - a little survey
Post by: JamesV6CDX on 25 September 2008, 16:42:30
Hi Guys,

I am not trying to start the comparison debate between pattern / Gen exhausts (as it's been done to death) - but I AM trying to do a little survey, so would appreciate a moment of your time :y

I am just interested to hear from Omega V6 owners with pattern exhausts on your cars. How do you find it - is it loud, tinny, has economy or performance dropped, was it poorly fitting, or on the flipside - do you find it OK?

Personally speaking, I have had pattern exhausts on 2.0 models that sounded AWFUL (TB will confirm ;D ) - yet I've had a pattern one on a 2.5 that really wasn't bad (apart from the fact it didn't seem to last too long).

If you can shed an opinion on this - please  answer the above and share if possible,

A) Where you bought it from
B) How much it cost
C) How long it's lasted
D) What make
 
Cheers muchly!
James
Title: Re: Exhausts - a little survey
Post by: Andy B on 25 September 2008, 16:52:08
Quote
.....

A) Where you bought it from
Jetex

Quote
B) How much it cost
£450-ish

Quote
C) How long it's lasted
about 5 years

Quote
D) What make
 
 ....James
as above in stainless steel

It's a bit noisier than I'd like & I'm not too keen on the size of the twin outlets.  :y
Title: Re: Exhausts - a little survey
Post by: Andyb on 25 September 2008, 16:59:16
its a patten part

got it from mutant cav didnt have money for vauxhall one

sounds terrible
very tinny and dont fit to well

the original was a gm part and it was guieter than this one untill the center box fell off lol
Title: Re: Exhausts - a little survey
Post by: tunnie on 25 September 2008, 17:15:17
Quote
Quote
.....

A) Where you bought it from
Jetex

Quote
B) How much it cost
£450-ish

Quote
C) How long it's lasted
about 5 years

Quote
D) What make
 
 ....James
as above in stainless steel

It's a bit noisier than I'd like & I'm not too keen on the size of the twin outlets.  :y


 :o :o :o
Title: Re: Exhausts - a little survey
Post by: Jay w on 25 September 2008, 17:40:42
Quote
Quote
Quote
.....

A) Where you bought it from
Jetex

Quote
B) How much it cost
£450-ish

Quote
C) How long it's lasted
about 5 years

Quote
D) What make
 
 ....James
as above in stainless steel

It's a bit noisier than I'd like & I'm not too keen on the size of the twin outlets.  :y


 :o :o :o

i know, you could have got a VX one and got change.....and it would have lasted longer  :y
Title: Re: Exhausts - a little survey
Post by: jereboam on 25 September 2008, 17:47:48
I've got no idea what's on mine, because I haven't had to change it.  I'm inclined to think it's still the original, as the bloke I bought it from didn't say that he'd replaced it, and he'd had it for 3 years.  

Is that likely?
Title: Re: Exhausts - a little survey
Post by: mantahatch on 25 September 2008, 17:54:42
Somewhere in Bristol

£350ish

5 years and still going strong.

Stainless steel one made to measure.

My dad had it fitted when he owned the car, he asked for it to be quiet, but there is quite a nice little growl from it when you open it up.

The only mistake I think he made with it is it has a round tail pipe, and I still prefer the oval tail pipe look.
Title: Re: Exhausts - a little survey
Post by: Robin Hood on 25 September 2008, 18:24:02
My original GM back box fell apart but the middle sections still appeared to have a good couple of years left in them so I just replaced the back with the cheapest item on Ebay at the time (£38 delivered from Eternalcar – Germany).

I assumed that when the middle sections finally fail, the pattern back box would also be on its way out and so I would then spring for a full GM system.  That was one and a half years ago now and the pattern part still looks fine.  It also fitted well and sounds OK.
Title: Re: Exhausts - a little survey
Post by: Marks DTM Calib on 25 September 2008, 18:57:42
Two original ones, quiet and easy to fit seem to be lasting well

One (expensive) pattern one, internals collapsed (note the warranty only covered anti performation!) within 18 months, noisey and a very poor fit.
Title: Re: Exhausts - a little survey
Post by: TheBoy on 25 September 2008, 19:08:36
Project TB1 had a pattern. No idea of cost, but it sounded bloody awful - like a farty 4 pot on full bore.
Title: Re: Exhausts - a little survey
Post by: Tony H on 25 September 2008, 19:40:18
Quote
I've got no idea what's on mine, because I haven't had to change it.  I'm inclined to think it's still the original, as the bloke I bought it from didn't say that he'd replaced it, and he'd had it for 3 years.  

Is that likely?
Quite possibly The oldest original Meega system I have heard about is seven years :y
Title: Re: Exhausts - a little survey
Post by: theolodian on 25 September 2008, 19:44:14
Pattern.

Came with the car.  Could look for receipt.

Been on 2-3 years.


It's not great, but OK.  At least until it gets really warm.  Then it gets really boomy, friggin annoying!  If the car wasn't so old I would rip it off and pay for a new MV6 system just to get rid of the boominess.  >:(
Title: Re: Exhausts - a little survey
Post by: ians on 25 September 2008, 19:52:39
6 years seems par for the course for the original GM system - pretty good really :y. (whether the replacement ones you get on TC will last the same is another matter :-/)

My experience
4 pot , pattern (from local indie tyre place),  lasted at least 2 years (sold car), sounded a bit throaty, cost £160.
V6 , Kwik fit, sounded perfectly fine, lasted exactly 4 years, cost £240
no complaints

actually after replacing it and being curious I unzipped that one with an angle grinder.   It appeared to be double skin which was in good nick, it was the end plates of the boxes and the pipe close by that had failed.  However the internal perforated pipe in all three boxes just fell out as a pile of rust!
Title: Re: Exhausts - a little survey
Post by: cem_devecioglu on 25 September 2008, 20:13:43
changed the section after the cats with the original , no problem..

changed the cats with another similiar flow silencers (non GM) , awful noise , too many problems..
Title: Re: Exhausts - a little survey
Post by: Phil on 25 September 2008, 20:20:39
3ltr MV6 (mini-facelift) - PowerFlow cat back stainless steel, £400, been on 4 years and no problems, went for a medium noise system, sounds fine.

2.5 CDX (facelift)- Kwick Fit pattern parts, £200 (because i argued as they pissed me about, should have been £240) noisier than GM one on there, and appears to be a bit short (tail pipe doesn't come past bumper) been on 3 1/2 years, of so far
Title: Re: Exhausts - a little survey
Post by: Andy B on 25 September 2008, 20:26:06
Quote
.....
 ........and it would have lasted longer  :y

Lasted longer than what? :-/ It's still on the car in the same condition it was as when I put it on.  :y
Title: Re: Exhausts - a little survey
Post by: dieseldean on 25 September 2008, 20:49:23
original exhaust downpipe and cat on recently retired 1994mig. 351000+miles. bosal branded middle and back only manage about 70000ish miles
Title: Re: Exhausts - a little survey
Post by: TheBoy on 25 September 2008, 20:59:51
Quote
original exhaust downpipe and cat on recently retired 1994mig. 351000+miles. bosal branded middle and back only manage about 70000ish miles
tractors seem to be less harsh on exhausts than petrols.