Omega Owners Forum
Chat Area => General Discussion Area => Topic started by: PaulW on 01 March 2009, 15:31:05
-
(http://i130.photobucket.com/albums/p266/PaulW21781/My%20Cars/Omega%20Elite/New%20Engine%20-%20Z32SE/DSC_0063.jpg)
Not the best picture... But what a bloody annoying design!! Finally got working properly on the Z32 today (I say working properly, I mean stripping bits off it)... Evil evil design! About a million torx screws to take off, then you think you have them all, there are more...
The whole lot comes off too, fuel rail, injectors, everything... I can see doing the camcover gaskets on one of these in the Vectra being a Complete ballache! More so than the Omega infact...
Only issue I has was 3 of the flange bolts have rounded a bit when trying to remove them, so have to go see if I can get some tools to undo them on Monday (motorfactors were shut by time this happened).
Also the amount of oil which is in the inlet system... Mucky thing!!