Omega Owners Forum
Chat Area => General Car Chat => Topic started by: mantahatch on 23 December 2009, 10:32:02
-
Is the towbar for the saloon the same for pre and facelift cars, and does the bumper require cutting on the facelift.
Thank you.
-
Yes, and yes as far as i know. And no...
Not sure on the ones that hide though, some environmently unfriendly burger van owners should be able to help you :-X
-
Yes, and yes as far as i know. And no...
Not sure on the ones that hide though, some environmently unfriendly burger van owners should be able to help you :-X
Thank you, I should add the only thing I tow is a 5x4 open trailer, and on occasions a car trailer.
-
Yes, and yes as far as i know. And no...
Not sure on the ones that hide though, some environmently unfriendly burger van owners should be able to help you :-X
Thank you, I should add the only thing I tow is a 5x4 open trailer, and on occasions a car trailer.
;D ;D ;D - Its just friendly jokes, i get enough stick from having a 4 pot, so i take the pi$$ when i can ;D
-
Regarding cutting the bumper, it depends on the towbar design, some do, some don't.
The facelift bumper also extends further back so some prefacelift towbar designs leave the ball a little close to the bumper when fitted to a facelift and vice versa.
Kevin
-
Regarding cutting the bumper, it depends on the towbar design, some do, some don't.
The facelift bumper also extends further back so some prefacelift towbar designs leave the ball a little close to the bumper when fitted to a facelift and vice versa.
Kevin
Thanks Kevin, looks like it will be time to get the ruler out.
-
We had to cut the bumper on mine .. facelift with irmscher body kit ... but done carefully it is fine.... just a "slot" the exact width of the bumper bar from the bottom edge of the bumper up to the top surface of the towbar. As the towbar at that point is square section it "looks" right and unless you look you would never know.
It was done with great care, using the "measure 4 times cut once whilst praying hard" technique.
I looked hard at a removeable hitch, but would still have had to cut the bumper, and then the cut would have been more visible whent he hitch was off .. if you get my drift !! :)
-
We had to cut the bumper on mine .. facelift with irmscher body kit ... but done carefully it is fine.... just a "slot" the exact width of the bumper bar from the bottom edge of the bumper up to the top surface of the towbar. As the towbar at that point is square section it "looks" right and unless you look you would never know.
It was done with great care, using the "measure 4 times cut once whilst praying hard" technique.
I looked hard at a removeable hitch, but would still have had to cut the bumper, and then the cut would have been more visible whent he hitch was off .. if you get my drift !! :)
Thank you Entwood, excelant advise regarding cutting.