Omega Owners Forum
Chat Area => General Car Chat => Topic started by: The Red Baron on 26 July 2010, 20:09:57
-
think i may know the answer but here goes,
3.0l elite 1998.
loosing coolant, no leaks external at all.
loosing like a header tank full in 10 miles.
no oil in water.
no water in oil.
not the matrix as no swimming pool in footwell.
runs ok.
idea`s. :-?
-
Any Rough running on initial start up?
Could well be, but I'd be after compression test results first :y :y
-
Any Rough running on initial start up?
Could well be, but I'd be after compression test results first :y :y
not got the car up here yet ld. ;)
-
A header tank in 10 minutes? I'd be seeing loads of white smoke if it were HG, wouldn't I?
I'd say it must be a leak, perhaps burning off on the exhaust manifold, so not hitting the floor?
-
think i may know the answer but here goes,
3.0l elite 1998.
loosing coolant, no leaks external at all.
loosing like a header tank full in 10 miles.
no oil in water.
no water in oil.
not the matrix as no swimming pool in footwell.
runs ok.
idea`s. :-?
;)
-
will have a look around the back of the oil cooler plate when it comes up here.
-
think i may know the answer but here goes,
3.0l elite 1998.
loosing coolant, no leaks external at all.
loosing like a header tank full in 10 miles.
no oil in water.
no water in oil.
not the matrix as no swimming pool in footwell.
runs ok.
idea`s. :-?
;)
LOL. I must learn to read properly. ;D
-
Might be worth checking the header tank cap and the neck where it screws on .. the cap safety valve can fail so it never pressurises properly , and the neck can develop small cracks that causes the same problem
If the system does not presurise it is running at very nearly boiling point.. so a great deal of evaporation takes place very quickly .. :) a bit like simmering a pan of water .. :)
-
Might be worth checking the header tank cap and the neck where it screws on .. the cap safety valve can fail so it never pressurises properly , and the neck can develop small cracks that causes the same problem
If the system does not presurise it is running at very nearly boiling point.. so a great deal of evaporation takes place very quickly .. :) a bit like simmering a pan of water .. :)
good point entwood. :y