Omega Owners Forum
Chat Area => General Car Chat => Topic started by: 51M0N on 13 May 2011, 08:39:51
-
Can I have an opinion on what I should inflate my tyres to as I'm unsure.
size is 235/35r19y
was thinking 32psi?
-
Sorry wrong section. on my phone >:(
-
235/45/17 is stated as 32 psi (for non loaded, non high speed), so wonder if your lower profile should be a bit harder :-/
-
depends on your daily commute roads.. if they are ok you can use 32 psi.. otherwise I wouldnt go down below 35 with those tires without risking them..
-
Normally to and from work. just me in the car 40mph or so
34 perhaps?
-
My Old Beemer had staggered Alloys 235-35-19 on the front that was 38 PSI and the rears were 265-30-19 they were 45 PSI.
So I'd say around 38.
-
My Old Beemer had staggered Alloys 235-35-19 on the front that was 38 PSI and the rears were 265-30-19 they were 45 PSI.
So I'd say around 38.
I have more or less this set up on my Mig Estate ('cept 275/30 /19 on rear)
- you need 'em that hard when cold? :o
What room for expansion when everything gets hotter?
Matthew
-
My Old Beemer had staggered Alloys 235-35-19 on the front that was 38 PSI and the rears were 265-30-19 they were 45 PSI.
So I'd say around 38.
Agreed with DELBOY, i had 38psi when i had a set of 19s on mine! :y
-
my tyre size is the same all round. so 38psi all round on a 235/3519 then folks?
-
my tyre size is the same all round. so 38psi all round on a 235/3519 then folks?
imo , really it depends on the road quality and your driving style.. however when the weather becomes hot you need to drop a bit..
-
roads are terrible, potholes speedbumps etc
-
So are we purely pumping up tyres to protect wheel rims from buckling on poor roads?
Because ideally an increase in load would be the only reason I'd increase psi. Otherwise the ride must be painful at 38psi surely....?
-
Grip must suffer as well I would have thought...?
-
no grip at all in the wet. just kicks out, all tyres are currently on 36psi
-
My Old Beemer had staggered Alloys 235-35-19 on the front that was 38 PSI and the rears were 265-30-19 they were 45 PSI.
So I'd say around 38.
I have more or less this set up on my Mig Estate ('cept 275/30 /19 on rear)
- you need 'em that hard when cold? :o
What room for expansion when everything gets hotter?
Matthew
They're the pressures BMW recommend, so I'll agree with BMW ;D
-
My Old Beemer had staggered Alloys 235-35-19 on the front that was 38 PSI and the rears were 265-30-19 they were 45 PSI.
So I'd say around 38.
I have more or less this set up on my Mig Estate ('cept 275/30 /19 on rear)
- you need 'em that hard when cold? :o
What room for expansion when everything gets hotter?
Matthew
They're the pressures BMW recommend, so I'll agree with BMW ;D
Where they run flats Del?
-
no grip at all in the wet. just kicks out, all tyres are currently on 36psi
What tyres?
My concern is the harder the tyre the less heat developed, less heat less grip. Too soft they get too hot they melt and degrade possibly damaging the structure obviously.
So varying the pressure without a variation on load worries me. Although clearly preferable to any damage.
Also the tyre is the first component in the suspension, a lower profile at stock psi will be firmer anyway....
-
no grip at all in the wet. just kicks out, all tyres are currently on 36psi
What tyres?
My concern is the harder the tyre the less heat developed, less heat less grip. Too soft they get too hot they melt and degrade possibly damaging the structure obviously.
So varying the pressure without a variation on load worries me. Although clearly preferable to any damage.
Also the tyre is the first component in the suspension, a lower profile at stock psi will be firmer anyway....
As I have stated above already, Only I drive the car so its not laden with weight, Its lowered and the tyre size is 235 35 19 all round
-
no grip at all in the wet. just kicks out, all tyres are currently on 36psi
What tyres?
My concern is the harder the tyre the less heat developed, less heat less grip. Too soft they get too hot they melt and degrade possibly damaging the structure obviously.
So varying the pressure without a variation on load worries me. Although clearly preferable to any damage.
Also the tyre is the first component in the suspension, a lower profile at stock psi will be firmer anyway....
As I have stated above already, Only I drive the car so its not laden with weight, Its lowered and the tyre size is 235 35 19 all round
But i suspect they are of budget origin.
-
no grip at all in the wet. just kicks out, all tyres are currently on 36psi
What tyres?
My concern is the harder the tyre the less heat developed, less heat less grip. Too soft they get too hot they melt and degrade possibly damaging the structure obviously.
So varying the pressure without a variation on load worries me. Although clearly preferable to any damage.
Also the tyre is the first component in the suspension, a lower profile at stock psi will be firmer anyway....
As I have stated above already, Only I drive the car so its not laden with weight, Its lowered and the tyre size is 235 35 19 all round
But i suspect they are of budget origin.
Size won't tell us how the tyres will perform, hence my question. Conti sc3 will perform well regards performance and grip levels. Michelin primacy will last for ever but grip is limited and they cost a fortune. However any budget tyre, as you say, will give very poor grip levels in the wet. So probably not the tyres pressure causing poor wet grip. Which is why i asked. Although 36psi certainly will not help.
Personally I think some budget tyres are bloody dangerous. They are capable of quite reasonable grip levels in the dry, leading to a false sense of security, until it rains and catching the driver totally unaware and sliding towards the ditch. As I guess you've probably discovered. ;D it's the terribly sorry old boy, I am a little tireding gap between wet and dry grip that's worrying.
-
my original question was what psi they should be inflated to regardless of wet or dry due to it not being a standard size. so far everyone is disageering with each other :-? :-/
-
Yes, because it's not a standard fitment. Therefore no vx recommendation for the omega. You'll not find any info on the vx or tyre makers web site. They'll quote Please read the manual.
If I had to guess, I'd look at another vx with stock 19's and go from there. Preferably a car of similar weight. One of the VXR vectras has 19's iirc. But the vectra will be lighter I would think.
It's up to you in the end. If the roads are crap and your worried about damage then you'll have to raise psi. But that aside it should be standard as the chart in FAQ IMO. Although I run 32 all round on my 3.2 with 245 40 18.
It's no wonder insurers charge for non standard or over sized wheel modifications. 19's are too big for the omega anyway if you ask me, but hay ho.
-
Or looking at it another way, start with stock and raise it depending on road quality. Trouble is if push comes to shove re insurance if psi is deemed too high you could potentially be in the poop. No?
-
Yes, because it's not a standard fitment. Therefore no vx recommendation for the omega. You'll not find any info on the vx or tyre makers web site. They'll quote Please read the manual.
If I had to guess, I'd look at another vx with stock 19's and go from there. Preferably a car of similar weight. One of the VXR vectras has 19's iirc. But the vectra will be lighter I would think.
It's up to you in the end. If the roads are crap and your worried about damage then you'll have to raise psi. But that aside it should be standard as the chart in FAQ IMO. Although I run 32 all round on my 3.2 with 245 40 18.
It's no wonder insurers charge for non standard or over sized wheel modifications. 19's are too big for the omega anyway if you ask me, but hay ho.
agreed..also together with lowered suspension and high pressure tires comfort will seriously degrade..
and another important subject , as the wheels and tires become very expensive at this size, most users prefer cheaper brands which also leads no grip in rain :(
-
Yes, because it's not a standard fitment. Therefore no vx recommendation for the omega. You'll not find any info on the vx or tyre makers web site. They'll quote Please read the manual.
If I had to guess, I'd look at another vx with stock 19's and go from there. Preferably a car of similar weight. One of the VXR vectras has 19's iirc. But the vectra will be lighter I would think.
It's up to you in the end. If the roads are crap and your worried about damage then you'll have to raise psi. But that aside it should be standard as the chart in FAQ IMO. Although I run 32 all round on my 3.2 with 245 40 18.
It's no wonder insurers charge for non standard or over sized wheel modifications. 19's are too big for the omega anyway if you ask me, but hay ho.
agreed..also together with lowered suspension and high pressure tires comfort will seriously degrade..
and another important subject , as the wheels and tires become very expensive at this size, most users prefer cheaper brands which also leads no grip in rain :(
In sc3 we're probably looking at £7-800 a set in that size.
-
Considering i'm on 19s and lowered i think the look small, as for ride quality its surprisingly comfortable!
Think i'll go with 34psi and see how it goes.
-
agreed..also together with lowered suspension and high pressure tires comfort will seriously degrade..and another important subject , as the wheels and tires become very expensive at this size, most users prefer cheaper brands which also leads no grip in rain :(
Comfort does definitely degrade, but then it falls on individuals whether you want the looks or the comfort? :-? Definitely cant get both. and budget tyres :-[ the name says it all doesnt it!! :y
-
...........I'm off to get Conti 3's for my Fronts this morning - Conti 2's on the rear on Friday (Conti 3 not available in 275/30/19 that I can find :-?)
I'm not going to have them as hard as has been suggested here so far - but I'll let you know how I get on.
38/45 - that's frightening! :o
Matthew
-
...........I'm off to get Conti 3's for my Fronts this morning - Conti 2's on the rear on Friday (Conti 3 not available in 275/30/19 that I can find :-?)
I'm not going to have them as hard as has been suggested here so far - but I'll let you know how I get on.
38/45 - that's frightening! :o
Matthew
I'm guessing the BMW must have those 'super reinforced' tyres on the back at least; 45psi cold would put most tyres well over their rated maximum when hot IIRC.
-
...........I'm off to get Conti 3's for my Fronts this morning - Conti 2's on the rear on Friday (Conti 3 not available in 275/30/19 that I can find :-?)
I'm not going to have them as hard as has been suggested here so far - but I'll let you know how I get on.
38/45 - that's frightening! :o
Matthew
I'm guessing the BMW must have those 'super reinforced' tyres on the back at least; 45psi cold would put most tyres well over their rated maximum when hot IIRC.
Talking with the Guy at the Tyre shop this morning:- he told me that 38/45 was with run flat tyres and he certainly wouldn't have 'em that hard on his M3 (So there's money in this tyre business, obviously!(and he was driving his other car - a merc!))
He also said the Contis can take a max 50 PSI at this size.
Mine were inflated to 32 on Friday and were at 40 after a 5 mile drive this morning (to the tyre shop).
I think I'll go with their recommendation of 32/34.
As for the new Contis - more sure footed - but can't tell about road noise as the Diff/rear Bearing rumbling buzz is too noisy to hear properly.
My front tyres were seriously worn on each outer edge, so he put her up and got me back into the green.
Why begs the question; should a trip to WIM be an annual one?
Matthew
-
Yes! Also see FAQ section BEFORE fitting new tyres. If you have uneven tyre wear, I would put your old wheels back on smart ish before your new ones are affected.
Then read and follow this. http://www.omegaowners.com/forum/YaBB.pl?num=1283124735
Once all your bushes, track rods, idlers and barings are sorted and its been set up then put your spangly wheels and tyres back on.... Although, if your old tyres are showing "some" inner edge wear At the end of their life that may just be the final result of the camber setting.
What where the before and after figures? You should be looking at 1.10!.... or 1.20 camber with sport suspension.
-
If it's of any help, my Monaro runs 245/35 19's & weighs in at 1688. Tyre pressures are 34 psi front & 36 psi rear.
HTH :)
-
If it's of any help, my Monaro runs 245/35 19's & weighs in at 1688. Tyre pressures are 34 psi front & 36 psi rear.
HTH :)
Thanks muchly :D