Omega Owners Forum

Newbie Area => Newbie Welcome Area => Topic started by: omega rod on 28 July 2009, 17:05:12

Title: omega v6 3.0l cutting out problem
Post by: omega rod on 28 July 2009, 17:05:12

hi i have been pulling my hair out with this fault.
right i bought car with cracked offside manufold, but car was running fine then about 2 weeks later car started cutting out,
if im doing 70 down the motorway or driving at 30 round town.when it cuts if i floor it after about 3 0r 4 seconds it fires up and is ok for 5 or 6 miles then does the same. sometimes all the dash lights come on and i have to put it in neutral and start it. the engine light does not come on.
i have changed the crankshaft sensor twice with no change. fault code 31 come on fault code but like i say i have fitted two crank sensors. i also hve oil lack come up randomly and coolent level. and some times the fuel gage shows nothing and then reads normal. hellllp. the car is a 96 3.0l v6 elite

Title: Re: omega v6 3.0l cutting out problem
Post by: Ziad on 28 July 2009, 17:15:27

Hello and welcome mate.

Please post your problem in the General Help Section where you're sure to have answers and all the help you'll need to sort out your problem  :y

Title: Re: omega v6 3.0l cutting out problem
Post by: Beverley on 28 July 2009, 17:24:35

Welcome to the forum :y

Title: Re: omega v6 3.0l cutting out problem
Post by: Lizzie_Zoom on 28 July 2009, 17:25:20

Hello and a very warm welcome to you! :y

Title: Re: omega v6 3.0l cutting out problem
Post by: Mr Skrunts on 28 July 2009, 17:28:13

Hi, welcome to the forum. 

Title: Re: omega v6 3.0l cutting out problem
Post by: Entwood on 28 July 2009, 17:28:23

"Hello" and Welcome :)

Title: Re: omega v6 3.0l cutting out problem
Post by: waspy on 28 July 2009, 17:57:45

Good afternoon. Welcome to the OOF :y

As Ziad says. Someone's sure to help :)

Title: Re: omega v6 3.0l cutting out problem
Post by: Seth on 28 July 2009, 18:10:10

Welcome bud!

Title: Re: omega v6 3.0l cutting out problem
Post by: omega rod on 28 July 2009, 18:16:48

thanks hello all miggy slaves

Title: Re: omega v6 3.0l cutting out problem
Post by: Ghost on 28 July 2009, 18:27:12

Hello and Welcome

Title: Re: omega v6 3.0l cutting out problem
Post by: djm1964 on 28 July 2009, 18:35:50

welcome to oof

Title: Re: omega v6 3.0l cutting out problem
Post by: dbug on 28 July 2009, 19:07:10

Welcome to OOF mate :y

Title: Re: omega v6 3.0l cutting out problem
Post by: AndyVXR300 on 28 July 2009, 19:09:54

Hi and welcome to the forum

Andy :y

Title: Re: omega v6 3.0l cutting out problem
Post by: Elitenut on 28 July 2009, 19:10:23

Hello and welcome to the Forum. :y :y

Title: Re: omega v6 3.0l cutting out problem
Post by: RobG on 28 July 2009, 21:53:47

Hello and welcome to the forum :y

Title: Re: omega v6 3.0l cutting out problem
Post by: Cliffo B on 29 July 2009, 01:22:20

Hello,welcme to the Forum :y

Title: Re: omega v6 3.0l cutting out problem
Post by: p j morgan on 29 July 2009, 01:47:18

welcome to oof :y

Title: Re: omega v6 3.0l cutting out problem
Post by: Elite Pete on 29 July 2009, 09:50:36

Hi and welcome :)

Title: Re: omega v6 3.0l cutting out problem
Post by: zirk on 01 August 2009, 12:26:58

Hi, welcome to the forum.    :y