Omega Owners Forum
Newbie Area => Newbie Welcome Area => Topic started by: rustym95 on 10 September 2009, 21:55:57
-
Hi a week ago she was working fine then on friday she had engine man light came on, she still ran and as i was at home I left it for the night, in morning the light was gone jsut thought it just was a 1off, then was going a long and the engine just cut out while was doing 60mph all light came on and engine man light, got her to side of the road, and a look could not see any thing wrong, started up first time but light stayed on(engine man) bit sluggish and would not go past 4.5 on rev starts cutting out, well any way long story short, got the RAC out cos was a long way from home, he could only find out that the cam sensor said it had a lose wire, ive changed that the next day and it still has the same problem, checked the timing belt it was off a bit so did that no change checked the wiring all ok, it has more power than before but still keeps cutting out or trying to, dose any one have any ideas thanks. :( :(
-
Welcome to OOF Rusty :y You need to do a paperclip test (see the bottom of my reply) and post it in the General Help section ;) :y
-
Hello & Welcome :y
-
Welcome along R :y :y
-
Hey M95 and welcome to OOF :y
-
Hi Rusty, welcome to OOF :y
-
Welcome to OOF mate :y
-
Hello and welcome to the Forum.
Brian. :y :y
-
Hi, welcome to the foum.
-
"Hello" and Welcome :)
-
Hi, welcome to the forum. :)
-
Hello and Welcome
-
Hi and welcome to the forum ;)
-
Welcome to the site :y
-
Hi thanks I will try that but dose it work on a 95, RAC did it and it come up with cam sensor, but I have changed that and checked the timing belt at same time and adjusted it as was out now et the pick up when driving but still the light coms on. is that picture on paper clip tust upside down as mine is on othere side thanks.
-
Hello and a very warm welcome to you! :y
-
welcome along :y
-
Welcome :y
-
Hello and a warm welcome