Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: JamesV6CDX on 25 March 2007, 10:34:32

Title: Head Gasket - knackered before fitting?
Post by: JamesV6CDX on 25 March 2007, 10:34:32
last night I inspected my V6 gasket kit....and put the head gaskets side by side.

There is a soft red seal that goes all around the edge of the gasket... but...

On one gasket, it runs true all along the top long straight of the gasket... however on the other gasket, it stats a few mm from the edge of the gasket at one end... and finishes up right by the edge of the gasket when it reaches the other end.. the line is not straight..

What does this red seal do on the HG...just an airtight seal? (If so, I might get away with it) and is this likely to cause me an issue?



Title: Re: Head Gasket - knackered before fitting?
Post by: Marks DTM Calib on 25 March 2007, 11:54:10
Its an additional water seal......no big deal as long as its tehre and continuous...

What make are the gaskets....Elring?
Title: Re: Head Gasket - knackered before fitting?
Post by: JamesV6CDX on 25 March 2007, 11:56:06
Quote
Its an additional water seal......no big deal as long as its tehre and continuous...

What make are the gaskets....Elring?

Yep, it's there and continuous....

The gasket set is FAI....
Title: Re: Head Gasket - knackered before fitting?
Post by: Marks DTM Calib on 25 March 2007, 11:57:06
Should be fine then...
Title: Re: Head Gasket - knackered before fitting?
Post by: JamesV6CDX on 25 March 2007, 12:01:49
Quote
Should be fine then...

Cool, I will take a pic later and post it up....