Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: andycuk71 on 19 May 2007, 18:41:17

Title: Oil cooler update
Post by: andycuk71 on 19 May 2007, 18:41:17
Well its all back together now just waiting to re cut the sump plug hole after it being stripped.

A big thank you to all that have helped with my questions have one more for you.... there are several very small plastic pipe/tubes about 2mm wide is there any info as to the correct configeration as to where they go????


Have taken lots of photos so will upload them next week

Thanks again everyone


Andy
Title: Re: Oil cooler update
Post by: Marks DTM Calib on 19 May 2007, 18:45:21
Yes, there is info on the vac pipe connections in the maintenance guides section
Title: Re: Oil cooler update
Post by: Markie on 19 May 2007, 18:56:38
congratulations on the job being done, i take it its as of yet not running....due to sump issue?
Title: Re: Oil cooler update
Post by: andycuk71 on 19 May 2007, 19:39:30
Sadly yes going to have to wait till at least tuesday night to see but at least I have not rushed the job but time and leaks will tell!!!!!!!!!!!!!!
Title: Re: Oil cooler update
Post by: Andy B on 19 May 2007, 21:26:08
Quote
Well its all back together now just waiting to re cut the sump plug hole after it being stripped.

..........

Andy

Would it not have been easier to just replace the steel sump pan? I can't remember price now but it wasn't too expensive - IIRC > £60 to replace it and the oil & filter.
Title: Re: Oil cooler update
Post by: Markie on 20 May 2007, 10:23:23
Quote
Sadly yes going to have to wait till at least tuesday night to see but at least I have not rushed the job but time and leaks will tell!!!!!!!!!!!!!!


 :y :y now the joy of flush flush flushing......