Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: Owen on 28 June 2007, 10:04:19

Title: paperclip test
Post by: Owen on 28 June 2007, 10:04:19

Paperclip test done, cheers for that bit of advice fella

the only code its coming up with is code19. Crank sensor right?

What I need to know is how hard a job is it to replace? With in my capabaility?
And also is it an expensive part, bearing in mind owt over a tenner is expensive on my budget ;D

Title: Re: paperclip test
Post by: x25xe on 28 June 2007, 10:08:41

Yes, code 19 is crank sensor.  Not hard at all to replace - I have done mine recently and it took around 45 minutes, that included a walk to the dealer to get the part.

There is a maint guide which describes how to do it - will have a search..

Title: Re: paperclip test
Post by: Timbuk on 28 June 2007, 10:09:54

Easy job really, i am just about to go and fit one on mine which arrived this morning :) 36 and 44 quid on ebay depending on which one it is :question Heres a link to how its done


http://www.omegaowners.com/forum/YaBB.pl?num=1174321688

Title: Re: paperclip test
Post by: x25xe on 28 June 2007, 10:11:25

Which is here:

http://www.omegaowners.com/forum/YaBB.pl?num=1174321688

I found that I could rear the connector without removing the windscreen scuttle - it is the small connector which on my car was next to the large connector at the back of the engine in the middle of the engine if that makes sense!

Title: Re: paperclip test
Post by: TheBoy on 28 June 2007, 10:34:14

Easy job.

Replace ASAP, it will let you done big time (::))

Title: Re: paperclip test
Post by: Marks DTM Calib on 28 June 2007, 10:46:02

Can somebody take a pic of the cable routing (after fitting), connector location etc so I can add them to the how to....

Ta

Title: Re: paperclip test
Post by: x25xe on 28 June 2007, 22:28:58

Quote

Can somebody take a pic of the cable routing (after fitting), connector location etc so I can add them to the how to....

Ta

Will try and post up tomorrow.