Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: sassanach on 09 September 2007, 09:09:38

Title: rpm signal
Post by: sassanach on 09 September 2007, 09:09:38
in the process of installing a omvl dream lpg system in my tub and the instructions call for a connection to give the ecu a rpm signal. in the "good ole days" that would be a connection to the coil but i wouldnt have a clue where to look on this tub. anyone got a clue?
Title: Re: rpm signal
Post by: Marks DTM Calib on 09 September 2007, 09:18:52
The crank sensor is one source but, not recommended.

Pin 43 of the ECU (Green) is the RPM output signal to the likes of the MID and rev counter etc.
Title: Re: rpm signal
Post by: sassanach on 09 September 2007, 12:21:21
any clue as to where this wire ends up in the front passenger footwell? there are a lot of wires there and two connection blocks