Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: omegalord on 18 September 2007, 22:38:32

Title: Problem after rocker gaskets?
Post by: omegalord on 18 September 2007, 22:38:32

Done the rocker gaskets , all running mint now apart from the hbv problem i now have

My question is....

When i start the car up first thing , it doesnt tick over at 1100rpm until warm anymore and if i rev it to about 4-5k rpm and lift off the accelerator , as the revs are coming down it pops and farts sometimes.

Any ideas?

Matt   :-/

Title: Re: Problem after rocker gaskets?
Post by: IrmscherKris on 18 September 2007, 22:46:15

Did you put the leads back on correctly?
Any oil in the plug wells?

EML going out ok?

Title: Re: Problem after rocker gaskets?
Post by: omegalord on 18 September 2007, 22:48:30

eml light is on , says its a plug at the back ram , it is plugged in but rams havent worked since i had it. There is still a bit of oil in the wells but couldnt clean it out any better then i did

Matt

Title: Re: Problem after rocker gaskets?
Post by: IrmscherKris on 18 September 2007, 22:56:15

You won't like this....
Strip down the plennum so you can access the back of the inlet and disconnect and reconnect all the plugs again - it's poss you have disturbed something when putting plennum back on.  :y

Title: Re: Problem after rocker gaskets?
Post by: omegalord on 18 September 2007, 23:00:03

I dont mind taking the plenum off , not a hard job.

I might actually take the plenum off and do the hbv valve while im there.

Matt